User manual SONY CD-U535

[. . . ] Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. CDX-3700 Serial No. Design and specifications are subject to change without notice. Caution alarm If you turn the ignition key switch to the OFF position without removing the front panel, the caution alarm will beep for a few seconds. AM Tuning range AM tuning interval: 9 kHz/10 kHz switchable 531 ­ 1, 602 kHz (at 9 kHz step) 530 ­ 1, 710 kHz *USA (at 10 kHz step) External antenna connector 10. 7 MHz/450 kHz 30 µV For installation and connections, see the supplied installation/connections manual. (RELEASE) Antenna terminal Intermediate frequency Sensitivity CDX-3700 © 1999 by Sony Corporation Printed in Japan Additional Information Precautions · If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. · If no power is being supplied to the unit, check the connections first. [. . . ] -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Welcome ! Thank you for purchasing the Sony Compact Disc Player. This unit lets you enjoy a variety of features. Maintenance Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Dismounting the unit 1 Press the clip inside the front cover with a thin screwdriver, and gently pry the front cover free. Before playing, clean the discs with an optional cleaning cloth. Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog discs. 2 Fuse (10 A) Repeat step 1 on the left side. The front cover is removed. Notes on handling CDs A dirty or defective disc may cause sound dropouts while playing. To enjoy optimum sound, handle the disc by its edge. To keep the disc clean, do not touch the surface. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. 3 Notes on moisture condensation On a rainy day or in a very damp area, moisture may condense on the lenses inside the CD player. To return to normal mode, press again until "MONO" disappears. 2 Press (MODE) repeatedly to select the band. Each time you press (MODE), the band changes as follows: " FM I " FM II " FM III " AM 3 Set the minute. To go forward To go backward Note If you try to store another station on the same number button, the previously stored station will be erased. 3 Press (SENS/BTM) for two seconds. The unit stores stations in the order of their frequencies on the number buttons. A beep sounds when the setting is stored. Changing the display item !§ LOUD (loudness) button 3 Press (DSPL). The clock starts. Notes · The unit does not store stations with weak signals. If only a few stations can be received, some number buttons will retain their former setting. · When a number is indicated in the display, the unit starts storing stations from the one currently displayed. · If a CD is not in the unit, only the tuner band appears even if you press (SOURCE). Receiving the memorized stations 1 2 3 Press (SOURCE) repeatedly to select the tuner. Press (MODE) repeatedly to select the band. Press the number button ((1) to (6)) on which the desired station is stored. Each time you press (DSPL), the item changes as follows: Frequency ~ Clock Troubleshooting guide CD Player Listening to a CD Insert a CD. Playback starts automatically. Label side up SEEK AMS Other Functions Locating a specific track -- Automatic Music Sensor (AMS) During CD playback, press either side of (SEEK/AMS) for each track you want to skip. To locate succeeding tracks To locate preceding tracks The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. General Problem Cause/Solution ·Adjust the volume with (+). [. . . ] ·The broadcast signal is too weak. No signal reception Preset tuning is not possible. Automatic tuning is not possible. Changing the display item Each time you press (DSPL) during CD playback, the item changes as follows: z Elapsed playing time Clock Z zTrack number Playing a CD in various modes Playing tracks repeatedly -- Repeat Play Press (1) during playback. "REPEAT" appears in the display. [. . . ]