User manual SONY CD-U55S

[. . . ] -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Welcome ! Thank you for purchasing this Sony Compact Disc Player. [. . . ] Attempting to do so may damage the unit. ·Before playing, clean the discs with a commercially available cleaning cloth. Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog discs. Maintenance Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Replacing the lithium battery Under normal conditions, batteries will last approximately 1 year. (The service life may be shorter, depending on the conditions of use. ) When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Removing the unit 1 Remove the front cover 1 Detach the front panel. 2 Press the clip inside the front cover with a thin screwdriver. Fuse (10 A) Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. x + side up 3 Repeat step 2 for the other side. 2 Remove the unit 1 Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. Cleaning the connectors The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, open the front panel by pressing (RELEASE), then detach it and clean the connectors with a cotton swab dipped in alcohol. Otherwise, the connectors may be damaged. Notes on lithium battery ·Keep the lithium battery out of the reach of children. During playback, press (3) (REP) repeatedly until "REP" indicator appears in the display. To return to normal play mode, press (3) (REP) again. Note When the last track on the disc is over, playback restarts from the first track of the disc. Playing tracks in random order -- Shuffle Play You can select to play the tracks on the current disc in random order. During playback, press (4) (SHUF) repeatedly until "SHUF" indicator appears in the display. tPress (OFF) again for 2 seconds to display the clock. · Remove the front panel and clean the connectors. See "Cleaning the connectors" for details. Stored stations and correct time are erased. Makes noise when the ignition key is in the ON, ACC, or OFF position. The leads are not matched correctly with the car's accessory power connector. If everything is in order, check the fuse. · The car does not have an ACC position. [. . . ] To return to normal, press (SENS) again. Selecting the sound position -- My Best sound Position (MBP) When you drive without passengers, you can enjoy the most comfortable sound environment with "My Best sound Position. " "My Best sound Position" has two presets, which adjust the sound level of balance and fader. You can select one very easily with the MBP button. Display window MBP-A MBP-B MBP-OFF Balance Level Right ­ 4dB 0 0 Left 0 ­ 4dB 0 Fader Level Front 0 0 0 Rear ­ 4dB ­ 4dB 0 Boosting the bass sound -- D-bass You can enjoy a clear and powerful bass sound. The D-bass function boosts the low frequency signal and high frequency signal with a sharper curve than conventional bass boost. You can hear the bass line more clearly even while the vocal volume remains the same. [. . . ]