User manual SONY CD-U625

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] When you need to ship the drive to another location, repacking it in its original container will help you transport it safely. This section provides the basic instructions you need to install the drive and host adapter in your computer. You should also read the manual of your computer for specifics of how to install internal devices. You need the following parts and tools (these are not supplied with the drive): · 0 mm from the surface of the side panels or the bottom plate. ) · Two mounting rails if your computer has mounting tracks. Unplug the computer and disconnect the cables attached to the back to give yourself more room to work. Do not turn on the power of the computer before completing the entire installation process. Set the jumpers on the rear of the drive in accordance with the configuration of your computer system. Removing the jumper from a jumper pin pair disables its corresponding function, and installing the jumper enables it. the recommended jumper for use is AMP Shunts (14227-1) , JAE Short Socket (PS-2SH4-1) or equivalent. The following table shows the function of each pair of jumper pins. Select an ID number which is not used by other SCSI devices connected to the bus. ID numbers and corresponding jumper pin setting are as follows: Jumper pin settings ID number 0 1 2 0 G G G 1 ® G G 2 G ® G 3 ® ® G 4 G G ® 5 ® G ® 6 G ® ® 7 ® ® ® G :Without jumper ® :With jumper :Factory setting TERM PREVENT/ ALLOW G :ACTIVE TERMINATOR OFF ® :ACTIVE TERMINATOR ON Enable: The disc drawer can be opened by pressing the eject button or by a software command. Disable: The disc drawer cannot be opened either by the eject button or a software command. ID SELECT, PREVENT/ALLOW, and TEST MODE are recognized only when the power is turned on or SCSI is reset. TEST MODE is reserved for use at the factory only. do not put a jumper over TEST MODE pins. Doing so may cause an unexpected result. 1 If your computer has its rear side covered by a plastic panel Attached with plastic hook pad, pull it off. Cover mounting screw If mounting rails are necessary, attach them to the drive in the same way as the ones on your floppy disk drive and slide the drive into the lower drive bay. [. . . ] The disc tray has four disc locks that prevent the disc from falling when the drive is set up in vertical position. When the drive is used in horizontal position, you do not need to lock the disc. S Locking and unlocking All of the four locks are set in the unlocked position (facing outward) when the drive is shipped from the factory. To set the lock in the locked position, turn it with your fingers until you hear a click so that it faces inward. [. . . ]