User manual SONY CDU948S-1

[. . . ] This unit uses CD-ROM discs with the following mark. When you use this unit as a CD player, use compact discs with the following mark. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] â· Unplug the computer and disconnect the cables attached to the back for your own safety. Do not turn on the power of the computer before completing the entire installation process. Set the jumpers on the rear panel of the drive unit in accordance with the configuration of your computer system. The jumpers are preset, as illustrated below, at the factory. The following table shows the function of each jumper. Jumper DEVICE TYPE Function The setting of this jumper determines whether the SCSI device type code in the inquiry data is WO or CD-ROM. ON: WORM OFF: CD-ROM Assign the drive unit's ID number by setting these jumpers to ON or OFF. Do not assign the same number as one used for other SCSI device. Used to prevent the SCSI bus interface connector from being plugged in upside down. ID SELECT, PREVENT/ALLOW, and TEST MODE are recognized when the power supply is turned on or SCSI bus is reset. â· TEST MODE is used exclusively for the factory testing. Doing so may cause an unexpected result. 1 If your computer has its rear side covered by a plastic panel Attached with plastic hook pad, pull it off. Note: The red edge of the flat cable should be positioned next to the power supply connector. 1 Route the flat cable through the drive bay from the front of the computer and insert the CD-R drive into the bay as shown. Secure the CD-R drive to the frame by using the prepared screws. Note: If you cannot secure the CD-R drive to the drive bay, you may need to install slide rails (not included) to the CD-R drive. 2 Locate an available power supply cable inside your computer and S Frame ground When normally installed, the drive unit is not in contact with the host computer directly and should be grounded. Connect the frame ground tab to one of the host computer's ground cables. Connect the free end of the flat cable to the existing SCSI host adapter card and install the host adapter in the computer by inserting it securely in a system expansion slot. Refer to the operating instructions of the host adapter for complete instructions on its installation and the assignment of its switches. The red edge of the flat cable must be closest to pin number 1 of the interface card connector. [. . . ] S Ejecting a caddy manually in an emergency In the event of electrical or mechanical failure of the drive unit, a manual emergency eject is provided to allow removal of the caddy from the drive unit. 1 Turn off the power of your computer. 2 Insert a pointed object, such as a paper clip, into the emergency After removing the caddy from the drive unit, consult your dealer or qualified service personnel. S General Host interface Read Function Acceptable discs: SCSI-2, single ended, 50 pin CD-ROM mode-1 data discs CD-ROM XA discs CD-Audio discs Audio-combined CD-ROM discs CD-I discs CD-I Ready Discs Photo CD (Single and Multi session) Video CD CD-R discs (Conforming to "Orange Book Part II") CD-ROM Mode-1 CD-ROM XA CD-Audio Audio-combined CD-ROM CD-I Video CD CD-Text Disc at once Session at once Track at once Variable packet writing (Packet size : max. [. . . ]