User manual SONY CDX-1000RF

[. . . ] Release when you have found the desired point. AMS Compact Disc Player Operating Instructions 1 AMS (Automatic Music Sensor) . button 2 AMS (Automatic Music Sensor) > button 3 Disc insertion slot 4 Z (eject) button 5 u (play/pause) button If pressed during playback, the CD will pause. If pressed again, playback will continue. 6 Reset button 7 Display window 8 SHUF (shuffle play) button 9 REPEAT (repeat play) button 0 DSPL (display mode change) button qa OFF button If a CD is already inserted, press u to start playback. Do not use rental CDs with old labels that are beginning to peel off. Stickers that are beginning to peel away, leaving a sticky residue Do not use your CDs with labels or stickers attached. [. . . ] Normally the initial output level is adequate; change the level if necessary. Maintenance Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Welcome ! Thank you for purchasing the Sony Compact Disc Player. This unit lets you enjoy a variety of features. 1 2 Press (REPEAT) for two seconds. Press (REPEAT) again. Initial setting 1 2 Press (REPEAT) for two seconds until frequency appears. Press either the left or right side of (AMS) to select the frequency. Each time you press (AMS), the frequency changes as follows: > : 88. 3 MHz t 88. 5 MHz t 88. 7 MHz t 88. 9 MHz t 89. 1 MHz t 89. 3 MHz t 89. 5 MHz t 89. 7 MHz t 89. 9 MHz t . : 88. 3 MHz t 89. 9 MHz t 89. 7 MHz t 89. 5 MHz t 89. 3 MHz t 89. 1 MHz t 88. 9 MHz t88. 7 MHz t 88. 5 MHz t Features ·Easy connection to any car audio with an FM tuner ·Dashboard installation for easy CD disc changing ·8X digital sampling filter for clear CD audio ·Quick recovery function to minimize disturbance from skips ·Repeat play function for playing tracks repeatedly ·Shuffle play fucnion for playing tracks in random order 3 Press either the left or right side of (AMS) to select the output level. To decrease the output level . :, To increase the output level Troubleshooting guide The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. Problem Cause/Solution · Another CD is already loaded. · The CD was forcibly inserted upside down. The ambient temperature exceeds 50°C (122°F). [. . . ] 8 in. ) Antenna connector*3 Note To prevent malfunction, install only with the supplied screws 7. Removing the unit Car audio Speaker system If you have a Sony car audio with the Sony BUS terminal, the optional source selector XA-107 can be used in your system. Sony car audio *2 You can also control the following functions with the rotary cammander RM-X4S: Power on ­ Press SOURCE. Locate a specific track ­ Rotate the SEEK/AMS control momentarily and release. Locate a specific point within a track ­ Rotate the SEEK/AMS control and release when the desired point is found. Adjust the volume ­ Rotate the volume control. [. . . ]