User manual SONY CDX-2160

[. . . ] ⷠIf no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. ⷠIf no sound comes from the speakers in 2-speaker systems, set the fader control to the center position. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. [. . . ] In either case, you can neither proceed to the previous nor the following track. The first 10 seconds of all the tracks are played. When you find the desired track, press the button once more. When the currently played track is over, it will be played again from the beginning. Release the button when the desired station is received. Press either side of the SEEK/AMS/MANU button once to search for the next station (automatic tuning). When tuning in during driving, use automatic tuning. Press either side of the SEEK/AMS/MANU button repeatedly until the desired station is received. When an FM stereo program with sufficient signal strength is tuned in, Stations with the clearest reception are automatically searched and memorized on each band (FM I, FM II, FM III and AM). Up to 6 stations on each band can be stored on the preset number buttons 1 to 6 in the order of band frequency. To keep the automatic tuning from stopping on stations too frequently (local seek mode), press the SENS button momentarily to get the "LOCAL" indication. Only the stations with relatively strong signals will be tuned in. The unit will be start scanning the selected band and memorize the tuned stations on the preset number buttons 1 through 6 automatically. Tune in the station which you wish to store on a preset number button. Press and hold the desired preset number button ( 1 to 6 ) for about two seconds until you hear a beep tone. The number of the pressed preset number button appears in the display window. Up to 6 stations on each band (FM I, FM II, FM III and AM) can be stored on the preset number buttons in the order of your choice. Therefore, 18 stations can be memorized on FM. [. . . ] Before going through the checklist below, refer to the connection and operating procedures. When the AMP/ANT REM lead is connected to the power antenna, the antenna will be extended as long as the unit is turned on. Press the 6 button for more than two seconds. The unit is installed at an angle of more than 20°. [. . . ]