User manual SONY CDX-3700

[. . . ] If you insert a disc within these 10 seconds, the unit will not be reset, and you will have to press the reset button again. You can detach the front panel of this unit to prevent the unit from being stolen. Be sure not to attach the front panel upside down. ⷠDo not press the front panel too hard against the unit when attaching it. [. . . ] Note If the automatic tuning stops too frequently, press (SENS/BTM) repeatedly until "LOCAL" (local seek mode) is displayed. Only the stations with relatively strong signals will be tuned in. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) until the desired frequency appears (manual tuning). Press and hold either side of (SEEK/AMS) to tune in the station that you want to store on the number button. Press and hold the desired number button ((1) to (6)) until "MEM" appears. To return to normal mode, press again until "MONO" disappears. Note If you try to store another station on the same number button, the previously stored station will be erased. Press the number button ((1) to (6)) on which the desired station is stored. Each time you press (DSPL), the item changes as follows: Each source can store the bass and treble levels independently. Only for cars with an accessory position on the ignition key switch To turn the Power Select Function ON Press (3) while pressing (SOUND). The Power Select Function ties the clock display power to the accessory position on the ignition key switch. To avoid battery wear, the clock is not displayed while the unit is initializing. Adjust within three seconds after selecting the item. Enjoy bass and treble even at low volume To return to normal mode, press again until "LOUD" disappears. To obtain the beep sound again, press these buttons again. Note If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. ⷠIf no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. ⷠIf no sound comes from the speakers of a two-speaker system, set the fader control to the centre position. [. . . ] The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. An optional power amplifier is connected and you are not using the built-in amplifier. The unit is installed at an angle of more than 60°. [. . . ]