User manual SONY CDX-52RF

[. . . ] If the disc magazine does not lock properly Take out the disc magazine, press (EJECT), and reinsert it. Use the unit with the door closed Otherwise, foreign matter may enter the unit, and contaminate the lenses inside the CD changer. Keep the lithium battery out of the reach of children. [. . . ] â· If you turn off the ignition switch of your car without stopping CD playback, it will automatically resume CD playback from where it was stopped the next time you turn on the ignition switch. When the unit is used in a car without an accessory position on the ignition key switch Be sure to press (OFF) on the wireless remote to turn the system off to avoid battery wear while the engine is not running. If the POWER SELECT switch on the hideaway unit is set to the OFF position and the display on the wired remote is turned off, you will not be able to start CD playback with the wireless remote. Be sure to stop CD playback before you start listening to the radio or a tape. Note Be sure to stop CD playback, otherwise there may be some interference with radio reception. Playing tracks in random order -- Shuffle Play During playback, press either side of (AMS) once for each track you wish to skip. Release the button when you have found the desired part. To go back to the normal playback mode, press (SHUF) until "SHUF" disappears. To search forward To search backward If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the system to cool off before operating it. â· If no power is being supplied to the system, check the connections first. If everything is in order, check the fuse. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. To go back to the normal playback mode, press (REP) until "REP" disappears. You can select the output level from the CD changer. [. . . ] Design and specifications are subject to change without notice. The following check will assist in the correction of most problems which you may encounter with your unit. Before going through the check list below, refer back to the connection and operating procedures. [. . . ]