User manual SONY CDX-705

[. . . ] When a disc magazine is inserted into the CD changer or the reset button of the connected car audio is pressed, the unit will automatically be activated and read the information on the CDs. When the information on all the CDs in the disc magazine has been read, the unit will automatically stop operation. [. . . ] Program memory function* for preselecting your favorite tracks from the discs in the changer, and playing them back in the order you want. * Only available when connected to a main that supports this function. The model and serial numbers are located at the rear of the CD changer. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block. ) Power requirement 12 V DC car battery (negative ground) Supplied accessories Disc magazine (1) Parts for installation and connections (1 set) Optional accessories Compact disc single adaptor CSA-8 Disc magazine XA-250 Source selector XA-C30 General disc magazine case GM-65 Design and specifications subject to change without notice. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] How to install the unit Note For connecting two or more changers, the XA-C30 source selector (optional) is necessary. When the unit is to be installed under the rear tray etc. [. . . ]