User manual SONY CDX-C4900R

[. . . ] This unit lets you enjoy a variety of features using the following controller accessories: Optional accessories Rotary commander RM-X4S Card remote commander RM-X91 In addition to the CD playback and radio operations, you can expand your system by connecting optional CD/MD units*1. When you operate this unit or a connected optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you playback a CD TEXT disc*2. This label is located on the bottom of the chassis. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. [. . . ] You can store up to 6 stations on each band (FM1, FM2, FM3, MW, and LW). Caution When tuning in stations while driving, use Best Tuning Memory to prevent accidents. You can preset up to 18 FM stations (6 each for FM1, FM2, and FM3), up to 6 MW stations, and up to 6 LW stations in the order of your choice. Press either side of (SEEK/AMS) to tune in the station that you want to store on the number button. Press the desired number button ((1) to (6)) for two seconds until "MEM" appears. Each time you press (SOURCE), the source changes as follows: * If the corresponding optional equipment is not connected, this item will not appear. Note If you try to store another station on the same number button, the previously stored station will be erased. Each time you press (MODE), the band changes as follows: Press (MENU), then press either side of (DISC/PRST) repeatedly until "BTM" appears. The unit stores stations in the order of their frequencies on the number buttons. The unit does not store stations with weak signals. If only a few stations can be received, some number buttons will retain their former setting. When a number is indicated in the display, the unit starts storing stations from the one currently displayed. If a CD is not in the unit, only the tuner band appears even if you press (SOURCE). Press the number button ((1) to (6)) on which the desired station is stored. During radio reception, press (MENU), then press either side of (DISC/PRST) repeatedly until "MONO-OFF" appears. Tip Press either side of (DISC/PRST) to receive the stations in the order they are stored in the memory (Preset Search Function). To return to normal mode, select "MONO-OFF" in step 2. Press either side of (SEEK/AMS) to search for the station (automatic tuning). Scanning stops when the unit receives a station. Press either side of (SEEK/AMS) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (MENU), then press either side of (DISC/PRST) repeatedly until "LOCAL" (local seek mode) is displayed. Only the stations with relatively strong signals will be tuned in. [. . . ] 2 kg Parts for installation and connections (1 set) Front panel case (1) Rotary commander RM-X4S Card remote commander RM-X91 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer (10 discs) CDX-828, CDX-737 MD changer (6 discs) MDX-65 Source selector XA-C30 *1 Equipped with front and rear outputs: CDX-C5000RX/C5000RV/C5000R only Equipped with rear outputs: CDX-C4900R *2 CDX-C5000RX/C5000RV/C5000R only Design and specifications are subject to change without notice. The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. Indications do not appear in the Remove the front panel and clean the connectors. [. . . ]