User manual SONY CDX-C5000X

[. . . ] For the use of release key qs, see the supplied operating instructions. Handle the bracket 1 carefully to avoid injuring your fingers. Be sure to connect the earth cord before connecting the amplifier. If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. [. . . ] notes on the control leads · The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner or when you activate the AF (Alternative Frequency), TA (Traffic Announcement) function. When your car has built-in FM/MW/LW aerial in the rear/side glass, connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. A power aerial without a relay box cannot be used with this unit. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities to avoid its damage. Do not connect the speaker terminals to the car chassis, or connect the terminals of the right speakers with those of the left speaker. Do not connect the earth lead of this unit to the negative (­) terminal of the speaker. To avoid a malfunction, do not use the built-in speaker wires installed in your car if the unit shares a common negative (­) lead for the right and left speakers. Do not connect the unit's speaker cords to each other. Bend these claws outward for a tight fit, if necessary. Avoid installing the rotary commander where it may be subject to high temperatures, such as from direct sunlight or hot air from the heater etc. Select "Nor" to use the rotary commander as the factory-set position. Select "Rev" when you mount the rotary commander on the right side of the steering column. Tip Rev/Nor cannot be selected on the side of master unit. 1 Press the buttons and rotate the controls to make sure that your master unit reacts well. You can change the direction of infrared rays by turning the dial on the rotary commander. Caution Be sure that the place where you install the rotary commander is within the range of receptor on the unit. Yellow Gelb Jaune Giallo Geel Yellow Gelb Jaune Giallo Geel continuous power supply permanente Stromversorgung alimentation continue alimentazione continua continu voeding Red Rot Rouge Rosso Rood Yellow Gelb Jaune Giallo Geel switched power supply geschaltete Stromversorgung alimentation commutée alimentazione commutata geschakelde voeding 2 Choose the exact location for the rotary commander to be mounted, then clean the mounting surface. Dirt or oil impair the adhesive strength of the doublesided adhesive tape. 3 Mark position for the supplied screw. Use the screw holes on the mounting hardware 0 to mark the positions. [. . . ] 4 Remove the steering wheel column cover, and drill 2 mm diameter hole where you have marked. 5 Warm the mounting surface and the double-sided adhesive tape on the mounting hardware 0 to the temperature of 20 °C to 30 °C , and attach the mounting hardware 0 onto the mounting surface by applying even pressure. Then screw it down with the supplied screw 9. On the other side of the mounting surface to cover the protruding tips of the screws so that they will not interfere with the electrical cables etc. [. . . ]