User manual SONY CDX-C560

[. . . ] The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] The recording date of the track is displayed for about three seconds. During playback, press either side of (SEEK/AMS) once for each track you want to skip. During playback, press and hold either side of (SEEK/AMS). Release the button when you have found the desired point. To go back to the normal playback mode, select "REP-OFF" in step 2 above. Playing tracks in random order -- Shuffle Play 3 Repeat steps 1 and 2 to enter the entire name. To return to the normal CD playback mode, press (LIST) for two seconds. Tip To erase/correct a name, enter "_" (under-bar) for each character. To go back to the normal playback mode, select "SHUF-OFF" in step 2 above. Each time you press (DSPL) during CD playback, the item changes as follows: You can label each disc with a personalized name. You can enter up to eight characters for a disc. If you label a CD, you can locate the disc by name and select the specific tracks for playback (page 13). Repeat steps 4 and 5 if you want to erase other names. Play the CD and press (LIST) for two seconds. If you want to enter a blank space between characters, select "_" (underbar). You can use this function with discs that have been assigned a custom name. For more information on disc names, refer to "Labeling a CD" (page 12). Note If you have not labeled the disc, the bank edit mode does not appear and the program edit mode appears. Press either side of (SEEK/AMS) to select the track number you want to skip and press (5) (ENTER). " If you want to return to "PLAY, " press (5) (ENTER) again. Once a disc name has been displayed for five seconds, the display goes back to its normal playback mode. The track names are not displayed during MD playback. [. . . ] POWER OUTPUT AND TOTAL HARMONIC DISTORTION 17 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 1 % total harmonic distortion. Other specifications CD player section System Signal-to-noise ratio Frequency response Wow and flutter Laser Diode Properties Material Wavelength Emission Duration Laser output power Compact disc digital audio system 90 dB 10 ­ 20, 000 Hz Below measurable limit GaAlAs 780 nm Continuous Less than 44. Outputs Line outputs (2) Equalizer output Power antenna relay control lead Power amplifier control lead Telephone mute control lead Illumination control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. ) Parts for installation and connections (1 set) Front panel case (1) Rotary remote RM-X2S Wireless remote RM-X41 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) RCA pin cord RC-63 (1 m), RC-64 (2 m), RC-65 (5 m) Cleaning cloth XP-CD1 Compact disc single adapter CSA-8 CD changer CDX-705 (10 discs), CDX-T65 (6 discs), CDX-T62 (6 discs) MD changer MDX-60, MDX-61 Source selector XA-C30 Digital preamplifier XDP-U50D TV tuner XT-40V, etc. [. . . ]