User manual SONY CDX-C6850R

[. . . ] This unit lets you enjoy a variety of features as well as a supplied rotary commander and an optional wireless remote. In addition to the CD playback and radio operations, you can expand your system by connecting an optional CD/MD unit*1. When you operate this unit or a connected optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play a CD TEXT disc*2. *1 You can also connect a CD changer, an MD changer, a CD player, or an MD player. [. . . ] You can select a different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. You can preset the volume level of the traffic announcements beforehand so you won't miss the announcement. When a traffic announcement starts, the volume will be automatically adjusted to the preset level. Press (AF/TA) repeatedly to select either "AF on", "TA on" or "AF TA on" (for both AF and TA functions). note that selecting "AF TA off" stores not only RDS stations , but also non-RDS stations. Press (SHIFT), then press (4) (PLAY MODE) repeatedly until "BTM" appears. If an emergency announcement comes in while you are listening to the radio, the programme will be automatically switched to it. If you are listening to a source other than the radio, the emergency announcements will be heard if you set AF or TA to on. The unit will then automatically switch to these announcements no matter which source you are listening to at the time. Tip The unit decreases the volume automatically when a telephone call comes in (Telephone ATT function). Press (SOUND) for two seconds while pushing the VOL control. Tip You can also change the operative direction of these controls with the unit (page 20). The following items can be set: · Contrast - to adjust the contrast if the indications in the display are not recognizable because of the unit's installed position. -- Select "norm" to use the rotary commander as the factory-set position. -- Select "rev" when you mount the rotary commander on the right side of the steering column. Loud (Loudness) - to enjoy bass and treble even at low volume. Note If you connect an optional power amplifier and do not use the buit-in amplifier, the beep sound will be disabled. Each time you press (3) (SET UP), the item changes as follows: Scrl* * When no CD or MD is playing, this item will not appear. For the "Contrast" setting, pressing (5) (n) makes the contrast higher, and pressing (2) (N) makes the contrast lower. After the mode setting is complete, the display returns to normal playback mode. By setting the cut off level of unwanted frequency signals, the speakers connected to the output terminal and/or the subwoofer(s) connected to the sub out terminal will out put a cleare sound image. To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). [. . . ] Outputs Line outputs (2) Power aerial relay control lead Power amplifier control lead Telephone ATT control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 2 kg Rotary Commander RM-X4S Parts for installation and connections (1 set) Front panel case (1) Wireless remote RM-X47 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) Cleaning cloth XP-CD1 Compact disc single adapter CSA-8 CD changer (10 discs) CDX-828, CDX-727 MD changer (6 discs) MDX-65 Other CD/MD changers with the Sony-BUS system Source selector XA-C30 Design and specifications are subject to change without notice. The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. [. . . ]