User manual SONY CDX-C780R

[. . . ] This unit lets you enjoy a variety of features by using either a supplied rotary commander or an optional wireless remote. In addition to the CD playback and radio operations, you can expand your system by connecting an optional CD/MD unit*1. If you operate this unit or connect an optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play back a CD TEXT disc*2. Playing tracks in random order -- Shuffle Play . [. . . ] Press (PTY/LIST) during FM reception until "PTY" appears. "- - - - -" appears if the received station is not an RDS station, or if the RDS data has not been received. The programme types appear in the order shown in the above table. When the unit finds the programme, the programme type appears again for five seconds. "NO" and the programme type appear alternately for five seconds if the unit cannot find the programme type. Note You cannot use this function in some countries where no PTY (Programme Type selection) data is available. Using the rotary commander the rotary commander works by pressing buttons and/or rotating controls. You can control an optional CD or MD unit with the rotary commander. Press (SHIFT), then press (3) (SET UP) repeatedly until "CT" appears. The CT function may not work even though an RDS station is being received. There might be a difference between the time set by the CT function and the actual time. Each time you press (SOURCE), the source changes as follows: Pressing (MODE) changes the operation in the following ways; Tip When the POWER SELECT switch is set to position B, you can turn on this unit by pressing (SOURCE) on the rotary commander. Rotate and hold the control until you locate the specific point in a track, then release it to start playback. If you need to mount the rotary commander on the right side of the steering column, you can reverse the operative direction. Press (SOUND) for two seconds while pushing the VOL control. Tip You can control the operative direction of controls with the unit (page 23). Each source can store the bass and treble levels respectively. -- Select "Auto" to dim the display only when you turn the lights on. Contrast to adjust the contrast if the indications in the display are not recognizable because of the unit`s installed position. -- Select "norm" to use the rotary commander as the factory-set position. -- Select "rev" when you mount the rotary commander on the right side of the steering column. Loud (Loudness) to enjoy bass and treble even at low volume. [. . . ] Back of the front panel Notes · For safety, before cleaning the connectors, turn off the engine and remove the key from the ignition switch. Never touch the connectors directly with your fingers or any metal device. Outputs Line outputs (3) Power antenna relay control lead Power amplifier control lead Telephone ATT control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 4 kg Rotary commander (1) Parts for installation and connections (1 set) Front panel case (1) Wireless remote RM-X47 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) Compact disc single adapter CSA-8 CD changer CDX-805 (10 discs), CDX-715 (10 discs), CDX-T65 (6 discs), CDX-T62 (6 discs) MD changer MDX-62 Source selector XA-C30 Design and specifications are subject to change without notice. [. . . ]