User manual SONY CDX-C910

[. . . ] Avoid installing the rotary remote where it may be subject to high temperatures, such as from direct sunlight or hot air from the heater etc. Choose the exact location for the rotary remote to be mounted, then clean the mounting surface. Dirt or oil impair the adhesive strength of the double-sided adhesive tape. [. . . ] press (RELEASE) to open up the front panel. Then slide the front panel a little to the left, and pull it off towards you. Align part A of the front panel to part B of the unit as illustrated, and push until it clicks. Mounting the unit in a japanese car You may not be able to install this unit in some makes of Japanese cars. Bracket Soporte ### Existing parts supplied to your car Piezas existentes suministradas con su automóvil ### Bracket Soporte ### Existing parts supplied to your car Piezas existentes suministradas con su automóvil ### ### ### Note To prevent malfunction, install only with the supplied screws 4 and use existing parts supplied to your car. This unit is designed for negative earth 12 V DC operation only. Before making connections, disconnect the earth terminal of the car battery to avoid short circuits. Connect the yellow and red power input leads only after all other leads have been connected. Be sure to connect the red power input lead to the positive 12 V power terminal which is energized when the ignition key is in the accessory position. Run all earth wires to a common earth point. If your car has no accessory position on the ignition key switch -- POWER SELECT switch The illumination on the front panel is factory-set to be turned on even when the unit is not being played. However, this setting may cause some car battery wear if your car has no accessory position on the ignition key switch. To avoid this battery wear, set the POWER SELECT switch located on the bottom of the unit to the B position, then press the reset button. The illumination is reset to stay off while the unit is not being played. [. . . ] Be sure to leave some slack in the connecting cord between the plug and the cramper. To a power aerial relay control box a la caja de relés de control de la antena motorizada ### Install the inverter far away from the unit using double-sided adhesive tape or something similar. Do not bundle the inverter's cord with a pincord or other connecting cord. [. . . ]