User manual SONY CDX-GT383A

[. . . ] Do not use second-hand or rental CDs that have a sticky residue on the surface (for example from peeled-off stickers or from ink, or glue leaking from under the stickers). Do not use rental CDs with old labels that are beginning to peel off. Stickers that are beginning to peel away, leaving a sticky residue Do not use your CDs with labels or stickers attached. You can play CD-Rs (recordable CDs) on this unit. [. . . ] Be sure not to drop the panel when detaching it from the unit. ⷠIf you detach the panel while the unit is still turned on, the power will turn off automatically to prevent the speakers from being damaged. ⷠWhen carrying the front panel with you, use the supplied front panel case. Attach part A of the front panel to part B of the unit as illustrated and push the left side into position until it clicks. When you connect the power supply cord to the unit or reset the unit, wait for about 10 seconds before you insert a disc. If you insert a disc within these 10 seconds, the unit will not be reset, and you will have to press the reset button again. You can detach the front panel of this unit to prevent the unit from being stolen. Be sure not to attach the front panel upside down. ⷠDo not press the front panel too hard against the unit when attaching it. ⷠDo not press too hard or put excessive pressure on the display window of the front panel. ⷠDo not expose the front panel to direct sunlight or heat sources such as hot air ducts, and do not leave it in a humid place. You can store up to 6 stations on each band (a total of 18 for FM I, FM II, and FM III, and 6 for AM) in the order of your choice. Press either side of (SEEK/AMS) to search for the station (automatic tuning). Scanning stops when the unit receives a station. Press either side of (SEEK/AMS) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (SENS/BTM) repeatedly until "LOCAL" (local seek mode) is displayed. Only the stations with relatively strong signals will be tuned in. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) to locate the frequency approximately, then press (SEEK/AMS) repeatedly to fine adjust to the desired frequency (manual tuning). Press and hold either side of (SEEK/AMS) to tune in the station that you want to store on the number button. Press and hold the desired number button ((1) to (6)) until "MEM" appears. To return to normal mode, press again until "MONO" disappears. Note If you try to store another station on the same number button, the previously stored station will be erased. [. . . ] Back of the front panel Notes · For safety, turn off the engine before cleaning the connectors and remove the key from the ignition switch. ⷠNever touch the connectors directly with your fingers or any metal device. Outputs Audio output Power amplifier control lead Power aerial relay control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative earth) Approx. 2 kg Card remote commander RM-X49 (CDX-3900 only) Parts for installation and connections (1 set) Compact disc single adapter CSA-8 Design and specifications are subject to change without notice. [. . . ]