User manual SONY CDX-GT40U

[. . . ] Be sure to install this unit in the dashboard of the car for safety. This label is located on the bottom of the chassis. Notice for customers: the following information is only applicable to equipment sold in countries applying EU Directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. the Authorized Representative for EMC and product safety is Sony Deutschland GmbH , Hedelfinger Strasse 61 , 70327 Stuttgart , Germany. [. . . ] The following items can be set: EQ7 PRESET (page 14) EQ7 SETTING (page 15) POSITION SET POSITION (Listening Position setting) (page 15) ADJ POSITION*1 (Listening Position adjustment) (page 16) SET SW POS*1 *2 (Subwoofer Position setting) (page 15) BALANCE Adjusts the sound balance: "RIGHT-15" ­ "CENTER" ­ "LEFT-15. Advanced Sound Engine creates an ideal incar sound field with digital signal processing. You can select an equalizer curve from 7 equalizer curves (XPLOD, VOCAL, EDGE, CRUISE, SPACE, GRAVITY, CUSTOM or OFF). Rotate the control dial until "EQ7 PRESET" appears, then press it. Rotate the control dial until the desired equalizer curve appears, then press it. Tip The equalizer curve setting can be memorized for each source. The unit can simulate a natural sound field by delaying the sound output from each speaker to suit your position. the options for "POSITION" are indicated below. FRONT L (): Front left FRONT R (): Front right FRONT (): Center front ALL (): In the center of your car OFF: No position set "CUSTOM" of EQ7 allows you to make your own equalizer settings. Rotate the control dial until "EQ7 SETTING" appears, then press it. Rotate the control dial until "BASE" appears, then press it. You can select an equalizer curve as a basis for further customizing. You can also set the approximate subwoofer position from your listening position if: ­ the audio output is set to "SUB-OUT" (page 17). ­ the listening position is set besides "OFF. 0 kHz Rotate the control dial to adjust the volume level, then press it. The volume level is adjustable in 1 dB steps, from -6 dB to +6 dB. Rotate the control dial until "SET POSITION" appears, then press it. Rotate the control dial to select from "FRONT L, " "FRONT R, " "FRONT" or "ALL, " then press it. Rotate the control dial until "SET SW POS" appears, then press it. Repeat steps and to adjust other frequency ranges. Rotate the control dial to select the subwoofer position from "NEAR, " "NORMAL" or "FAR, " then press it. Rear Bass Enhancer enhances the bass sound by applying the low pass filter setting (page 17) to the rear speakers. [. . . ] ­ a disc to which data can be added. For discs with very many characters, those may not scroll. ­ Install the unit at an angle of less than 45° in a sturdy part of the car. HUB NO SUPRT (Hubs Not Supported) USB hub is not supported on this unit. [. . . ]