User manual SONY CDX-GT447UE

[. . . ] Press (OPEN), then slide the front panel to the right side, and pull out the left side. Place the hole in the front panel onto the spindle on the unit as illustrated, then push the left side in. Bend these claws outward for a tight fit, if necessary. When installing this unit: Depending on car type, the mounting angle may not allow the front panel to open easily. [. . . ] When installing this unit: Depending on car type, the mounting angle may not allow the front panel to open easily. in such a case , remove the silver screw A shown below. When screwing it on again, first lock the lever B. Attaching the screw without doing so may cause the unit to break. When the installation and connections are completed, be sure to press the reset button with a ball-point pen, etc. This unit is designed for negative ground 12 V DC operation only. Be careful not to pinch any wires between the screw and the body of the car, or this unit, or between any moving parts such as the seat railing, etc. Connect the power connecting cord 8 to the unit and speakers before connecting it to the auxiliary power connector. Run all ground wires to a common ground point. Connect the yellow cord to a free car circuit rated higher than the unit's fuse rating. Warning when installing in a car without ACC (accessory) position on the ignition key switch Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turning off the engine. When you press (OFF) only momentarily, the clock display does not turn off and this causes battery wear. Be sure to connect the ground cord before connecting the amplifier. If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. *1 Note for the aerial connecting If your car aerial is an ISO (International Organisation for Standardisation) type, use the supplied adaptor 6 to connect it. First connect the car aerial to the supplied adaptor, then connect it to the aerial jack of the master unit. Anslut först motorantennen till medföljande adapter och därefter till antennuttaget på huvudenheten. Rotary commander RM-X4S (not supplied) Mando rotativo RM-X4S (no suministrado) Vridkontroll RM-X4S (medföljer inte) Comando rotativo RM-X4S (não fornecido) Insert with the cord upwards. Auxiliary power connectors may vary depending on the car. Be sure to check the power connection diagram. [. . . ] Auxiliary power connectors may vary depending on the car. Be sure to check the power connection diagram. Improper connections may damage your car. If the supplied power connecting cord can not be used with your car, consult your nearest Sony dealer. [. . . ]