User manual SONY CDX-GT637UI

[. . . ] Do not insert a disc within these 10 seconds; otherwise, the unit will not be reset, and you will have to press the reset button again. Be sure not to attach the front panel upside down. â· Do not press the front panel hard against the unit when attaching it. Do not press hard or put excessive pressure on the display window of the front panel. [. . . ] Note When there is no alternative station in the area and you do not need to search for an alternative station, turn the AF function off by pressing (AF/TA) repeatedly until "AF TA" disappears. Each time you press (AF/TA), the item changes as follows: " AF " TA Blank " * Select this to turn on both the AF and TA functions. If the station name starts flashing after selecting a station with the AF function on, this indicates that no alternative frequency is available. Press (SEEK/AMS) while the station name is flashing (within eight seconds). The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI SEEK" appears and no sound is heard). If the unit cannot find another frequency, "NO PI" appears, and the unit returns to the originally selected frequency. Note The "*" indication means that an RDS station is being received. Each time you press (DSPL), the item changes as follows: Note "NO NAME" appears if the station received does not transmit RDS data. The "REG" (regional on) function of this unit lets you stay tuned to a regional programme without being switched to another regional station. (Note that you must turn the AF function on. ) The unit is factory preset to "REG, " but if you want to turn off the function, do the following. You can select a different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. You can locate the station you want by selecting one of the programme types shown below. Note If the countries or regions where EON data is not transmitted, you can use this function only for the stations you have tuned in once before. Press (AF/TA) repeatedly to select either "AF, " "TA" or "AF TA" (for both AF and TA functions). Note that turning the "AF TA" function off stores RDS stations as well as non-RDS stations. Presetting different settings for each preset station Press (AF/TA) repeatedly to select either "AF, " "TA" or "AF TA" (for both AF and TA functions). Press the desired number button for two seconds until "MEM" appears. Repeat from step 1 for presetting other stations. Tip If you want to change the preset AF and/or TA setting after you tune in the preset station, you can do so by turning on/off the AF or TA function. Note You cannot use this function in some countries where no PTY (Programme Type selection) data is available. Press (PTY) during FM reception until "PTY" appears. [. . . ] To keep the disc clean, do not touch the surface. To obtain the beep tone again, press these buttons again. Do not stick paper or tape on the labelled surface. Do not expose the discs to direct sunlight or heat sources such as hot air-ducts, or leave them in a car parked in direct sunlight where there can be a considerable rise in the temperature inside the car. [. . . ]