User manual SONY CDX-GT828U

[. . . ] Tip When carrying the front panel, use the supplied front panel case. Engage part A of the front panel with part B of the unit, as illustrated, and push the left side into position until it clicks. Press (DSPL) again to return to the previous display. With the card remote commander In step 4, to set the hour and minute, press M or m. [. . . ] Scanning stops when the unit receives a station. Repeat this procedure until the desired station is received. Tip If you know the frequency of the station you want to listen to, press and hold (SEEK) +/­ to locate the approximate frequency, then press (SEEK) +/­ repeatedly to fine adjust to the desired frequency (manual tuning). After 3 seconds, the setting is complete and the display returns to normal play/reception mode. With the card remote commander In step 3, to adjust the selected item, press <, M, , or m. Using optional remote commander Card remote commander RM-X114 location of controls The corresponding buttons on the card remote commander control the same functions as those on this unit. With the card remote commander In step 3, to select the setting, press < or , . The following items can be set (follow the page reference for details): "z" indicates the default settings. The following buttons on the card remote commander have also different buttons/functions from the unit. (For details of other operations, see "With the card remote commander" on each pages. ) · M/m (DISC*/PRESET +/­) buttons For details, see "With the card remote commander" on each pages. Before playing, clean the discs with a commercially available cleaning cloth. 2 Engage the release keys together with the protection collar. Some CD-Rs/CD-RWs (depending on the equipment used for its recording or the condition of the disc) may not play on this unit. ⷠYou cannot play a CD-R/a CD-RW that is not finalized. If you have any questions or problems concerning your unit that are not covered in this manual, consult your nearest Sony dealer. 3 Pull out the release keys to remove the protection collar. When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. if the fuse blows , check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. 1 Insert both release keys simultaneously until they click. The unit may not function properly if the connectors between the unit and the front panel are not clean. [. . . ] Makes noise when the position of the ignition key is switched. The leads are not matched correctly with the car's accessory power connector. ⷠThe disc has been forcibly inserted upside down or in the wrong way. The CD-Rs/CD-RWs are not for audio use (page 9). [. . . ]