User manual SONY CDX-GT937UI

[. . . ] If you press (RELEASE) to detach the panel while the unit is still on, the unit will turn off automatically to prevent the speakers from being damaged. When you carry the front panel with you, put it in the supplied front panel case. Align part A of the front panel to part B of the unit as illustrated, and push until it clicks. When you connect the power supply cord to the unit or reset the unit, wait for about 10 seconds before you insert a disc. [. . . ] Note The "*" indication means that an RDS station is being received. Each time you press (DSPL), the item changes as follows: Note "NO NAME" appears if the station received does not transmit RDS data. By using this function, you can continuously listen to the same programme during a longdistance drive without having to re-tune the station manually. If the station name starts flashing after selecting a station with the AF function on, this indicates that no alternative frequency is available. Press (SEEK/AMS) while the station name is flashing (within eight seconds). The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI SEEK" appears and no sound is heard). If the unit cannot find another frequency, "NO PI" appears, and the unit returns to the originally selected frequency. The "REG" (regional on) function of this unit lets you stay tuned to a regional programme without being switched to another regional station. (Note that you must turn the AF function on. ) The unit is factory preset to "REG, " but if you want to turn off the function, do the following. Press (AF/TA) for more than two seconds until "REG" disappears. To cancel all traffic announcements, turn off the function by pressing (AF/TA) until "AF" and "TA" disappear. When you preset RDS stations, the unit stores each station's data as well as its frequency, so you don't have to turn on the AF or TA function every time you tune in the preset station. You can select a different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. You can locate the station you want by selecting one of the programme types shown below. Note If the countries or regions where EON data is not transmitted, you can use this function only for the stations you have tuned in once before. Press (AF/TA) repeatedly to select either "AF, " "TA" or "AF TA" (for both AF and TA functions). Note that turning the "AF TA" function off stores RDS stations as well as non-RDS stations. Presetting different settings for each preset station Press (AF/TA) repeatedly to select either "AF, " "TA" or "AF TA" (for both AF and TA functions). Press the desired number button for two seconds until "MEM" appears. Repeat from step 1 for presetting other stations. Tip If you want to change the preset AF and/or TA setting after you tune in the preset station, you can do so by turning on/off the AF or TA function. [. . . ] If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. If no sound comes from the speakers of a two-speaker system, set the fader control to the centre position. [. . . ]