User manual SONY CDX-L430X

[. . . ] The numbers in the list are keyed to those in the instructions. First connect the black earth lead, then connect the yellow and red power input leads. [. . . ] Connect the yellow and red power input leads only after all other leads have been connected. Run all earth wires to a common earth point. Be sure to insulate any loose unconnected wires with electrical tape for safety. notes on the power supply cord (yellow) · When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. When no car circuits are rated high enough, connect the unit directly to the battery. The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner. When your car has built-in FM/AM aerial in the rear/side glass, connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. A power aerial without relay box cannot be used with this unit. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities to avoid its damage. Do not connect the speaker terminals to the car chassis, or connect the terminals of the right speakers with those of the left speaker. [. . . ] You may not be able to install this unit in some makes of Japanese cars. Bracket Soporte Existing parts supplied with your car Piezas existentes suministradas con su automóvil Existing parts supplied with your car Piezas existentes suministradas con su automóvil [. . . ]