User manual SONY CDX-L490X

[. . . ] A Volume control dial 17 b DSO button 27 c Z (eject) button (located on the front side of the unit, behind the front panel) 9 d SOURCE (Power on/Radio/CD/MD) button 8, 9, 10, 11, 13, 14, 17, 20, 27, 28 e Display window f Receptor for the card remote commander g MENU button 9, 11, 12, 13, 17, 19, 21, 23, 26, 27, 28 h DISPLAY/PTY (display mode change/ programme type) button 10, 11, 15, 18, 23, 28 i SCROLL button 10 j OPEN button 8, 9 k LIST button CD/MD 11, 12 RADIO 15, 22 l EQ7 button 27 m RESET button (located on the front side of the unit, behind the front panel) 7 * Warning when installing in a car without An ACC (accessory) position on the ignition switch After turning off the ignition, be sure to press (OFF) on the unit for 2 seconds to turn off the clock display. Otherwise, the clock display does not turn off and this causes battery drain. Card remote commander RM-X114 (optional) (DISC/PRESET) (­): to select downwards In menu mode, the currently selectable button (s) of these four are indicated with a " v" in the display. The corresponding buttons of the card remote commander control the same functions as those on this unit. [. . . ] Note If you try to store another station on the same number button, the previously stored station will be erased. FM stations with Radio Data System (RDS) service send inaudible digital information along with the regular radio programme signal. For example, one of the following will be displayed upon receiving a station with RDS capability. Press either side of (DISC/PRESET) repeatedly until you find the desired station. Receiving traffic announcements, even when enjoying another programme/source. Depending on the country or region, not all of the RDS functions are available. ⷠRDS may not work properly if the signal strength is weak or if the station you are tuned to is not transmitting RDS data. The alternative frequencies (AF) function allows the radio to always tune into the area's strongest signal for the station you are listening to. Press either side of (SEEK) while the station name is flashing (within 8 seconds). The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI Seek" appears). If the unit cannot find the same PI, the unit returns to the previously selected frequency. The level indication increases as the strength of the receiving signal increases. Level 1 level 2 level 3 level 4 Note To display the level indication, turn off the Motion Display (page 26). If you know the channel number of ensemble, follow the procedure below to tune in. " Press either side of (DISC/PRESET) until "Ch. Press either side of (DISC/PRESET) repeatedly until the desired channel number appears. The BTM (Best Tuning Memory) function picks out DAB ensembles and automatically assigns the services within the ensembles to preset service numbers. If you activate the BTM function while listening to a preset service, the unit will store detected services (by overwriting) only to preset numbers higher than that of the current present service. ⷠIf you activate the function while listening to a service that is not preset, the unit will replace the contents of all preset numbers. ⷠIn both cases above, if the unit detects a service that is identical to one already preset, the previously stored service remains unchanged and the newly detected service is not preset. You can also preset DAB services manually or delete a service which is already preset. Note that up to 40 services (preset either by the BTM function or manually) can be preset to the unit's memory. [. . . ] ⷠThe CD/MD is forcibly inserted upside down or in the wrong way. You tried to playback a CD-R not designed for audio use. ⷠSome CD-Rs may not play due to its recording equipment or the disc condition. The power connecting cord is not connected properly. [. . . ]