User manual SONY CDX-L550X

[. . . ] Run all earth wires to a common earth point. Be sure to insulate any loose unconnected wires with electrical tape for safety. notes on the power supply cord (yellow) · When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. [. . . ] When no car circuits are rated high enough, connect the unit directly to the battery. Front speaker Frontlautsprecher Haut-parleur avant Diffusori anteriori Voorluidspreker Rear speaker Hecklautsprecher Haut-parleur arrière Diffusori posteriori Achterluidspreker Power amplifier Endverstärker Amplificateur de puissance Amplificatore di potenza Eindversterker CD/MD changer CD/MD-Wechsler Changeur de CD/MD Cambia CD/MD CD/MD-wisselaar Rotary commander RM-X4S Joystick RM-X4S Satellite de commande RM-X4S Telecomando a rotazione RM-X4S Bedieningssatelliet RM-X4S The numbers in the list are keyed to those in the instructions. Handle the bracket 1 carefully to avoid injuring your fingers. Be sure to connect the earth cord before connecting the amplifier. If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. Tip (2-B- ) For connecting two or more CD/MD changers, the source selector XAC30 (optional) is necessary. Connecting any other system may damage the unit. If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 8 may damage the aerial. After matching the connections and switched power supply leads correctly, connect the unit to the car's power supply. If you have any questions and problems connecting your unit that are not covered in this manual, please consult the car dealer. Bend these claws outward for a tight fit, if necessary. Choose the installation location carefully so that the unit will not interfere with normal driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. How to detach and attach the front panel (4) Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF). [. . . ] How to detach and attach the front panel (4) Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF). Press (RELEASE), and pull it off towards you. [. . . ]