User manual SONY CDX-M8805X

[. . . ] notes · Be sure to use only the supplied mounting hardware for a safe and secure installation. ) only after making sure there is nothing on the other side of the mounting surface. When you install the CD changer, be careful not to damage wiring or equipment on the other side of the mounting surface. [. . . ] Use the appropriate screw holes according to your preference. When the unit is to be installed under the rear tray or in the trunk, observe the following. ⷠChoose the mounting location carefully so that the unit can be installed horizontally. ⷠMake sure the unit does not hinder the action of the torsion bar spring, hinge, etc. After installing the unit, align the dials with one of the marks so that the arrow comes as close to a vertical position as possible. Note Be sure to align the left and right dials with the same mark. Because this unit processes CD playback sound through an FM tuner, there may be interference noise during CD playback. ⷠBe sure to connect the red power input lead to the positive 12 V power terminal which is powered when the ignition switch is in the accessory position. ⷠRun all ground wires to a common ground point. ⷠWhen finished making all the connections, press the reset button of the CD changer. The use of optical instruments with this product will increase eye hazard. To a metal point on the car First connect the black ground lead, then connect the yellow and red power input leads. To the +12 V power terminal which is powered at all times Be sure to connect the black ground lead first. To the +12 V power terminal which is powered when the ignition switch is in the accessory position Be sure to connect the black ground lead first. [. . . ] To the +12 V power terminal which is powered when the ignition switch is in the accessory position Be sure to connect the black ground lead first. * An adaptor (optional) may be necessary for your car and car audio system. Plug the connector into the jack on the left side of the CD changer. [. . . ]