User manual SONY CDX-S2000

[. . . ] Thank you for purchasing this Sony Compact Disc Player. You can enjoy its various features even more with: · cD TEXT information (displayed when a CD TEXT disc* is played) · Optional controller accessories Card remote commander RM-X114 Rotary commander RM-X4S This label is located on the bottom of the chassis. I AF button 12, 13, 14 j ATT (attenuate) button 17 k SENS/BTM button 10, 11, 14 l RESET button (located on the front side of the unit, behind the front panel) 7 m Number buttons Radio: Storing the desired station on each number button. CD: (3): REP 10 (4): SHUF 10 n PTY (programme type) button 15 o DSPL (display mode change) button 9, 12 p TA button 13, 14 q EQ3 button 18 r Receptor for the card remote commander * Warning when installing in a car without an ACC (accessory) position on the ignition switch After turning off the ignition, be sure to press and hold (OFF) on the unit until the display disappears. [. . . ] Press the number button ((1) to (6)) on which the desired station is stored. During radio reception, press (SENS) (BTM) repeatedly until "MONO-ON" appears in the display. Scanning stops when the unit receives a station. Repeat the operation until the desired station is received. You can manually preset the desired stations on any chosen number button. If the automatic tuning stops too frequently, press (SENS) (BTM) repeatedly until "LOCAL-ON" appears in the display. Press the desired number button ((1) to (6)) for 2 seconds until "MEM" appears. Only the stations with relatively strong signals will be tuned in. Tip If you know the frequency of the station you want to listen to, press and hold (SEEK) (+) or (SEEK) (­) to locate the approximate frequency, then press (SEEK) (+) or (SEEK) (­) repeatedly to fine adjust to the desired frequency (manual tuning). Note If you try to store another station on the same number button, the previously stored station will be erased. FM stations with Radio Data System (RDS) service send inaudible digital information along with the regular radio programme signal. For example, one of the following will be displayed upon receiving a station with RDS capability. The AF function allows the radio to always tune into the area's strongest signal for the station you are listening to. The unit starts searching for an alternative frequency with a stronger signal in the same network. Receiving traffic announcements, even when enjoying another programme/source. Depending on the country/region, not all of the RDS functions are available. RDS will not work properly if the signal strength is too weak or if the station you are tuned to is not transmitting RDS data. If you want to change the on/off setting while playing a CD, press (AF). When there is no alternative frequency in the area or when you do not need to search for one, turn the AF function off by selecting "AF-OFF. The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI SEEK" appears). If the unit cannot find the same PI, the unit returns to the previously selected frequency. These settings function regardless of the current FM programme/source, CD; the unit switches back to the original source when the bulletin is over. [. . . ] The power connecting lead is not connected properly. The unit is installed at an angle of more than 45°. The unit is not installed in a sturdy part of the car. An optional power amplifier is connected and you are not using the built-in amplifier. [. . . ]