User manual SONY CDX-S2010T

[. . . ] Choose the installation location carefully so that the unit will not hamper the driver during driving. Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. [. . . ] Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press the OFF button first. Then press the RELEASE button to open up the front panel, and detach the panel by pulling it towards you as illustrated. Align the parts A and B, and push the front panel until it clicks. The numbers in the list are keyed to those in the instructions. The release key 4 is used for dismounting the unit. When the installation and connections are over, be sure to press the reset button with a ballpoint pen etc. Front speakers Haut-parleurs avant Pin Colour Broche Couleur 4 Rear speakers Haut-parleurs arrière 5 Yellow Jaune Blue Bleu Function Fonction continuous power supply alimentation continue power antenna control antenne électrique Switched power supply alimentation commutée ground masse Note on the control leads The power antenna control lead (blue) supplies +12 V DC when you turn on the tuner. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. [. . . ] Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. [. . . ]