User manual SONY CD-X1300

[. . . ] 178 × 50 × 178 mm (7 1/8 × 2 × 7 1/8 in. ) (w/h/d) Approx. 182 × 53 × 162 mm (7 1/4 × 2 1/8 × 6 1/2 in. ) (w/h/d) Approx. 10 oz. ) Parts for installation and connections (1 set) Compact disc single adapter CSA-8 Do not use rental CDs with old labels that are beginning to peel off. Stickers that are beginning to peel away, leaving a sticky residue Fuse (10 A) FM/AM Compact Disc Player Operating Instructions 2 Repeat step 1 on the left side. The front cover is removed. Notes on handling CDs A dirty or defective disc may cause sound dropouts while playing. [. . . ] · Do not expose the front panel to direct sunlight or heat sources such as hot air ducts, and do not leave it in a humid place. Never leave it on the dashboard of a car parked in direct sunlight or where there may be a considerable rise in temperature. CAUTION The use of optical instruments with this product will increase eye hazard. Caution alarm If you turn the car ignition off without removing the front panel, the caution alarm will beep for a few seconds. If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. (RELEASE) *I-3-043-466-12*(1) Location of controls Setting the clock The clock has a 12-hour digital indication. Example: To set the clock to 10:08 Radio Memorizing stations automatically -- Best Tuning Memory (BTM) This unit selects the stations with the strongest signals and memorizes them in the order of their frequencies. You can store up to 6 stations on each band (FM I, FM II, FM III, and AM). Troubleshooting guide The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. 1 2 SOURCE BTM Press (DSPL) during operation. Press (DSPL) for two seconds. Memorizing only the desired stations You can store up to 6 stations on each band (a total of 18 for FM I, FM II, and FM III, and 6 for AM) in the order of your choice. If you cannot tune in a preset station Press either side of (SEEK/AMS) to search for the station (automatic tuning). Scanning stops when the unit receives a station. Press either side of (SEEK/AMS) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (SENS/BTM) repeatedly until "LOCAL" (local seek mode) is displayed. Only the stations with relatively strong signals will be tuned in. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) to locate the frequency approximately, then press (SEEK/AMS) repeatedly to fine adjust to the desired frequency (manual tuning). General Problem No sound. Cause/Solution ·Adjust the volume with (+). ·Set the fader control to the center position for two-speaker systems. ·The power cord or battery has been disconnected. ·The reset button has been pressed. t Store the settings again into the memory. ·An optional power amplifier is connected and you are not using the built-in amplifier. ·The beep sound is cancelled. SENS MODE SEEK AMS D-BASS SOUND REPEAT SHUF ATT The hour indication flashes. OFF The contents of the memory have been erased. No beep sound. 1 2 3 4 5 6 DSPL 1 Set the hour. CDX-1200 1 2 3 4 Caution To go forward To go backward Press (SOURCE) repeatedly to select the tuner. Press (MODE) repeatedly to select the band. press and hold either side of (SEEK/AMS) to tune in the station that you want to store on the number button. Press and hold the desired number button ((1) to (6)) until "MEM" appears. [. . . ] B D-BASS 1 B D-BASS 2 OFF b B D-BASS 3 To Stop playback Eject the CD Press Z or (OFF) Z Note If " " or " " appears in the display, you have reached the beginning or the end of the disc and you cannot go any further. Cancel the beep sound Press (6) while pressing (SOUND). To obtain the beep sound again, press these buttons again. Note If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. Changing the display item Each time you press (DSPL) during CD playback, the item changes as follows: B Elapsed playing time Clock b B Track number Playing a CD in various modes Playing tracks repeatedly -- Repeat Play Press (1) during playback. "REPEAT" appears in the display. When the current track is over, it will play again from the beginning. [. . . ]