User manual SONY CD-X3700

[. . . ] · Do not press the front panel too hard against the unit when attaching it. · Do not press too hard or put excessive pressure on the display window of the front panel. · Do not expose the front panel to direct sunlight or heat sources such as hot air ducts, and do not leave it in a humid place. Never leave it on the dashboard of a car parked in direct sunlight or where there may be a considerable rise in temperature. Owner's Record The model and serial numbers are located on the bottom of the unit. [. . . ] Should this occur, the unit will not operate properly. In this case, remove the disc and wait for about an hour until the moisture evaporates. Cleaning the connectors The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, open the front panel by pressing (RELEASE), then detach it and clean the connectors with a cotton swab dipped in alcohol. Otherwise, the connectors may be damaged. Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. CAUTION The use of optical instruments with this product will increase eye hazard. Do not stick paper or tape on the labeled surface. When you play 8 cm (3 in. ) CDs Use the optional Sony compact disc single adapter (CSA-8) to protect the CD player from damage. 4 Repeat step 3 on the right side. Main unit 5 Back of the front panel Notes · For safety, turn off the engine before cleaning the connectors and remove the key from the ignition switch. · Never touch the connectors directly with your fingers or any metal device. Slide the unit out of the mounting. *I-3-866-876-21*(1) Location of controls Setting the clock The clock has a 12-hour digital indication. Example: To set the clock to 10:08 Radio Memorizing stations automatically -- Best Tuning Memory (BTM) This unit selects the stations with the strongest signals and memorizes them in the order of their frequencies. You can store up to 6 stations on each band (FM I, FM II, FM III, and AM). 1 2 SOURCE BTM Press (DSPL) during operation. Press (DSPL) for two seconds. Memorizing only the desired stations You can store up to 6 stations on each band (a total of 18 for FM I, FM II, and FM III, and 6 for AM) in the order of your choice. If you cannot tune in a preset station Press either side of (SEEK/AMS) to search for the station (automatic tuning). Scanning stops when the unit receives a station. Press either side of (SEEK/AMS) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (SENS/BTM) repeatedly until "LOCAL" (local seek mode) is displayed. Only the stations with relatively strong signals will be tuned in. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) until the desired frequency appears (manual tuning). SENS MODE SEEK AMS ATT RELEASE LOUD The hour indication flashes. OFF REPEAT SHUF SOUND 1 2 3 4 5 6 DSPL 1 Set the hour. To go forward To go backward 1 2 3 4 CDX-3700 Caution When tuning in stations while driving, use Best Tuning Memory to prevent accidents. Press (SOURCE) repeatedly to select the tuner. Press (MODE) repeatedly to select the band. press and hold either side of (SEEK/AMS) to tune in the station that you want to store on the number button. Press and hold the desired number button ((1) to (6)) until "MEM" appears. The number button indication appears in the display. 1 Refer to the pages for details. 1 MODE (band select) button 2 SOURCE (source select) button 3 (+) (­) (volume/bass/treble/left-right/ front-rear control) buttons 4 Display window 5 SEEK/AMS (seek/Automatic Music Sensor/manual search) control 6 6 (eject) button 7 SENS/BTM (sensitivity adjust/Best Tuning Memory) button 8 ATT (attenuate) button 9 RELEASE (front panel release) button 0 SOUND button !¡ Reset button (located on the front side of the unit hidden by the front panel) !TM During radio reception: Number buttons During CD playback: (1) REPEAT button (2) SHUF button !£ DSPL (display mode change/time set) button !¢ OFF button !Frequency select switch (located on the bottom of the unit) The AM (FM) tuning interval is factory-set to the 10 K (200 K) position. Make sure that the 10 K (200 K) position is selected. The minute indication flashes. Press (SOURCE) repeatedly to select the tuner. [. . . ] When the current track is over, it will play again from the beginning. To return to normal playback mode, press again. Cancel the beep sound Press (6) while pressing (SOUND). To obtain the beep sound again, press these buttons again. Note If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. The "STEREO" indication flashes. Error displays The following indications will flash for about five seconds. Display Cause A CD is dirty or inserted upside down. [. . . ]