User manual SONY CFD-222L

[. . . ] 12 Using the display 13 Locating a specific point in a track 14 Playing tracks repeatedly (Repeat Play) 15 Creating your own program (Program Play) 18 20 22 23 24 16 Choosing the power sources 17 Adjusting the sound emphasis (TONE/MEGA BASS) Press again to resume play after pause. Go to the next track Go back to the previous track Remove the CD Turn off the player If the received FM stereo is too weak, the reception becomes monaural. With the side you want to play facing forward Note During playback, do not press buttons on the other deck. Otherwise the playback speed may change. [. . . ] Using the player on batteries Insert eight R20 (size D) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. Turn the control clockwise to enhance the high tone and counterclockwise to enhance the low tone. To return to normal sound, press the button again. As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. on power sources · For AC operation, check that the player's operating voltage is identical with your local power supply (see "Specifications") and use the supplied AC power cord; do not use any other type. The voltage selector is located at the bottom of the player (CFD-DW222 only). ⷠThe player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. ⷠDo not place the player on an inclined or unstable place. ⷠDo not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. ⷠIf the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. ⷠSince a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. on operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. ⷠIf the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. Before playing, clean the CD with a cleaning cloth. [. . . ] To make the best possible recording, however, we recommend that you clean all surfaces over which tape travels before each recording. Demagnetizing the tape heads After 20 to 30 hours of use, enough residual magnetism will have built up on the tape heads to begin to cause loss of high frequency sound and hiss. At this time, you should demagnetize the heads and all metal parts in the tape path with a commercially available tape head demagnetizer. Cleaning the cabinet Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. [. . . ]