User manual SONY CFD-577

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] 2 Set the frequency to the station you want. 3 Press and hold the number buttons that you want to preset the new station on for 2 seconds. 1 2 3 4 5 Press RADIO BAND until the band you want appears in the display. Set the frequency to the station you want. Press and hold DISPLAY ENT MEM for 2 seconds. Press PRESET + or ­ until the preset number (1 to 10) you want for the station flashes in the music calender. The frequency digits flash in the display and the station is stored into the player's memory. The new station replaces the old one. The Radio 19 Playing preset radio stations Once you have preset the stations, use PRESET +/­ on the player or the number buttons on the remote (CFDZW750/ZW770 only) to tune in to your favorite stations. RADIO BAND PRESET ­, + On the remote (CFDZW750/ZW770 only) 1 Press BAND to select the band. 2 Press the number buttons to tune in the stored station. 1 2 Press RADIO BAND to select the band. Each time you press DISPLAY ENT MEM, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and re-enter it. To use the player before a timer playback starts Just turn on the player, and then you can use it. The graphic equalizer will not work in any other position. If you have selected MANUAL on page 28, slide 5 BAND GRAPHIC EQUALIZER to select the audio emphasis you want. Frequency coverage MEGA BASS 400 Hz Slide the control up (to MAX/+10) to increase heavy bass sound to emphasize speaking voice, middle frequencies of instrumental music to provide more presence of vocals to heighten overall brightness of sound to increase high treble sounds Slide the control down (to MIN/­10) to decrease heavy bass sound Setting Up to de-emphasize speaking voice, middle frequencies of instrumental music to provide less presence of vocals to lessen overall brightness of sound to decrease high treble sounds or reduce high frequency noise/tape hiss 1 kHz 4 kHz 10 kHz Setting Up 29 Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. On power sources · For AC operation use the supplied AC power cord; do not use any other type. · The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use six size D (R20) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. [. . . ] · Make sure the safety tab of the cassette is in place. · Clean the heads, pinch rollers and capstans (See page 34). · Demagnetize the heads using a demagnetizer (see page 34). · The TYPE II (high position) or TYPE IV (metal) tape is being used. [. . . ]