User manual SONY CFD-646

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. For customers in the United States This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] + (forward) or = (backward) in pause and hold down until you find the point. A point while listening to the sound You can play tracks repeatedly in normal, shuffle or program play modes (see pages 16 ­ 18. Playing a single CD repeatedly Playing two or three CDs repeatedly Playing tracks of a single CD in random order repeatedly Playing tracks of two or three CDs in random order repeatedly To cancel repeat play Press REPEAT until "REPEAT" disappears in the display. Playing tracks in random order (Shuffle Play) You can play tracks in random order. Playing tracks of a single CD in random order Playing tracks of two or three CDs in random order To cancel shuffle play Press PLAY MODE/MONO/ST until "SHUF" disappears in the display. You can make a program of up to 20 tracks from all the CDs in the order you want them to be played. Press AMS/SEARCH =/ + then press ENTER/ MEMORY instead of the number buttons. ⷠYou can play the same program again, since the program is saved until you open the CD tray. ⷠYou can record your own program. After you've created the program, insert a blank tape into deck B and press r on deck B to start recording. Press the number buttons for the tracks you want to program in the order you want. CD number Track number Playing order If you made a mistake, press CLEAR and re-enter the track number. To program additional tracks from another CD, repeat steps 2 and 3. To check the order of tracks before play Press ENTER/MEMORY on the player. Every time you press the button, the track number appears in the programed order. to change the current program To Erase the last track in the program Do this 1 Press CLEAR. Every time you press the button, the last track in the program is cleared. Then create a new program following the programing procedure. You can store radio stations into the player's memory. You can preset up to 20 radio stations, 10 for each FM or AM in any order. TUNE +/­ BAND Tip To preset radio stations on the player, proceed as follows: 1 Select the band and tune in a station you want. 2 Hold down ENTER/ MEMORY for about 2 seconds. [. . . ] Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. ⷠIf the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. [. . . ]