User manual SONY CFD-980

[. . . ] For customers in Canada To prevent electric shock, match wide blade of plug to wide slot, fully insert. Model No. ________________________ 2 Introduction Table of contents Basic Operations Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player 12 Using the display 13 Locating a specific point in a track 14 Playing tracks repeatedly (Repeat Play) 15 Playing tracks in random order (Shuffle Play) 16 Creating your own program (Program Play) 19 21 23 24 25 Additional Information Precautions Troubleshooting Maintenance Specifications Index Setting Up 17 Choosing the power sources 18 Adjusting the sound emphasis (TONE/MEGA BASS) Introduction 3 Basic Operations Playing a CD 3 4 1, 2 Connect the supplied AC power cord (see page 17). 1 Press 6 PUSH OPEN/CLOSE down to open the CD compartment and place a CD on the CD compartment. With the label side up 2 Close the CD compartment. 3 Set FUNCTION to CD. 4 Basic Operations 4 Press ^ . The player plays all the tracks once. Display Basic Operations Track number Playing time Use these buttons for additional operations VOLUME ^ 6 PUSH OPEN/CLOSE p =, + FUNCTION To adjust the volume stop playback pause playback Do this Turn VOLUME. Set FUNCTION to TAPE· CD/RADIO OFF. go to the next track go back to the previous track remove the CD turn off the player Basic Operations 5 Listening to the radio 1 2 Connect the supplied AC power cord (see page 17). 1 Set FUNCTION to FM or AM. 2 Turn TUNING to tune in a radio station. [. . . ] 3 Press r. To stop recording pause recording Press p6 P Press the button again to resume recording. Basic Operations 11 The CD Player Using the display DISPLAY ENTER You can check information about the CD using the display. Checking the total track number and playing time Check the display in stop mode. Total playing time Total track number Checking the remaining time Press DISPLAY·ENTER while playing a CD. To display remaining time on the current track* remaining time on the CD and the number of tracks left playing time and the current track number Press DISPLAY·ENTER once twice three times * For a track whose number is more than 20, the remaining time appears as "- -:- -" in the display. 12 The CD Player Locating a specific point in a track You can locate a specific point in a track while playing a CD using + or =. =, + The CD Player To locate a point while listening to the sound Press + (forward) or = (backward) while playing and hold down until you find the point. + (forward) or = (backward) in pause and hold down until you find the point. a point while observing the display The CD Player 13 Playing tracks repeatedly (Repeat Play) You can play tracks repeatedly in normal, shuffle or program play modes (see page 16). FUNCTION PLAY MODE =, + ^ 1 2 Set FUNCTION to CD. Proceed as follows: To repeat a single track Do this 1 Press PLAY MODE until "REP 1" appears. 2 Select the track by pressing the = or + and press ^. 1 Press PLAY MODE until "REP ALL" appears. 1 Press PLAY MODE until "SHUF REP" appears. 1 Press PLAY MODE until "PGM REP" appears. 2 Program tracks (see step 3 on page 16). 3 Press ^. all the tracks tracks in random order programmed tracks To cancel Repeat Play Press PLAY MODE until "REP" disappears from the display. 14 The CD Player Playing tracks in random order (Shuffle Play) You can play tracks in random order. PLAY MODE FUNCTION ^ The CD Player 1 2 3 Set FUNCTION to CD. Press PLAY MODE until the "SHUF" appears in the display. Press ^ to start shuffle play. To cancel Shuffle Play Press PLAY MODE until "SHUF" disappears from the display. The CD Player 15 Creating your own program (Program Play) You can arrange the playing order of up to 20 tracks on a CD. PLAY MODE FUNCTION DISPLAY =, + ENTER ^ Tips · You can play the same program again, since the program is saved until you open the CD compartment or switch FUNCTION. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. · If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. continued Additional Information 19 Precautions (continued) Notes on CDs · Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. Notes on cassettes · Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape. Side A · Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. [. . . ] · Move the player away from the TV. · If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV. Make sure that the CD compartment is closed. Clean with a commercially available blower. [. . . ]