User manual SONY CFD-E100

[. . . ] Component code numbers TV The left row of the table shows the brand, the right row shows the code number. Analog cable box Brand Hamlin/Regal Jerrold/G. I Code No. 022, 023, 024, 025, 026 031, 001, 002, 003, 004, 005, 006, 007, 008, 018, 022, 032 027, 028, 029 019, 020, 021 014, 015 009, 010, 011 031, 016, 017 012, 013 Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. [. . . ] Hold down TUNE (TUNE/CH on the remote) + or ­ until the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button repeatedly to change the frequency step by step. Tip If the FM broadcast is noisy, press MODE repeatedly until "Mono" appears in the display and the radio will play in monaural. Recording 1 2 Press xZ to open the tape compartment and insert a blank tape. Select the program source you want to record. To record from the CD player Press x and load a CD (See "Playing a CD"). To record from the radio Press RADIO BAND·AUTO PRESET and tune in the station you want (See "Listening to the radio"). Searching for the correct code If you've tried all the code numbers listed for your component and you still cannot get the remote to work (or if your component is not listed in the "Component code numbers" tables on the front side), try these steps. 1 2 3 4 5 Power on the component you want to set up. Press the button of the component on the remote that you want to set up (TV or CBL). Repeat step 4 until the correct code number is found. Each time you press TUNE/CH+ and then POWER, a new code number will be transmitted. Keep trying until your component operates by receiving the transmitted signal from the remote (e. g. , the power turns off, the channel function works, playback starts, etc. ) Be patient as you do this; it may take about 70 tries until the correct code number is located. 6 When the correct code is found, press ENT to store the code number in the remote's memory. 7 Check that the remote is operating the other functions of your component by pressing the corresponding buttons on the remote. If they seem to be working properly, you're done setting up the remote. If the component does not operate properly, repeat steps 1 to 6 and search for another code. Remote Control POWER SLEEP FUNCTION Number buttons MODE TUNE/CH +, ­ ENT VOL +*, ­ x X . , > MUTING SET 1 2 3 4 Press Z OPEN to open the CD compartment. Load a CD in the CD compartment until it clicks into place. Press PUSH CLOSE to close the CD compartment. The player plays all the tracks once. Do this Press x. Press the button again to resume play after pause. Press >. 2 To stop playback pause playback go to the next track 3 Press z to start recording. (N is depressed automatically. ) Press xZ X Press the button again to resume recording. * PRESET +, ­ . , > x MEGA BASS VOLUME +*, ­ RADIO BAND MEGA BASS find the beginning of the current Press . . track/go back to the previous track remove the CD Press Z OPEN. [. . . ] For example, if you're setting up a Philips' TV, you would use the code number 011. If your component isn't listed, see "Searching for the correct code. " 2 While pressing SET, press POWER on the remote. 3 Press the button of the component that you want to set up (TV or CBL). 4 Enter the component's code number. [. . . ]