User manual SONY CFD-E100L

[. . . ] As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. , heart, square, star) cannot be played on this player. Break off the cassette tab from side A or B to prevent accidental recording. [. . . ] If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error. Clean the CD, or replace it if the CD is badly damaged. â· Place the player in a location free from vibration. â· Clean the lens with a commercially available blower. â· The sound may drop out or noise may be heard when using poor quality CD-Rs/CDRWs or if there is a problem with the recording device or application software. Replace all the batteries in the remote with new ones if they are weak. â· Make sure that you are pointing the remote at the remote sensor on the player. â· Remove any obstacles in the path of the remote and the player. â· Make sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light. â· Move closer to the player when using the remote. After trying the above remedies, if you still have problems, unplug the mains lead and remove all the batteries. After all the indications in the display disappear, plug the mains lead and insert the batteries again. This player can play CD-Rs/CD-RWs recorded in the CD-DA format*, but playback capability may vary depending on the quality of the disc and the condition of the recording device. Music discs encoded with copyright protection technologies This product is designed to play back discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product. If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. â· If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. Connect the mains lead A or insert six R14 (size C) batteries (not supplied) into the battery compartment B . Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. [. . . ] 2 While keeping the AC power cord connected, press N of the TAPE section on the player. 3 Disconnect the AC power cord from the wall outlet. 4 While keeping PRESET + and MODE pressed, reconnect the AC power cord to the wall outlet. 5 The tuning interval is changed and "AM 9" "MW 9" or "AM 10" "MW 10" appears in the display for 2 seconds. [. . . ]