User manual SONY CFD-E55L

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. [. . . ] 4 Select the preset number you want to preset the new station on by turning the jog dial. The new station replaces the old one. On the remote 1 Press BAND until the band you want appears in the display. 2 Press TUNE + or ­ until you tune in the station you want. 3 Hold down the number button that you want to preset the new station on for 2 seconds. To select the preset number over 10, press >10 first, then the corresponding number buttons. You need to hold down the last number button to enter for about 2 seconds. (Example: To select 12, press >10 and 1 first, then hold down 2 for about 2 seconds. ) 1 2 3 Press RADIO BAND·AUTO PRESET to select the band. Hold down RADIO BAND·AUTO PRESET for 2 seconds until "AUTO" appears in the display. The stations are stored in memory from the lower frequencies to the higher ones. 16 Playing preset radio stations Once you've preset the stations, use the jog dial on the player or the number buttons on the remote to tune in to your favorite stations. RADIO BAND AUTO PRESET The Radio Jog dial 1 2 Press RADIO BAND·AUTO PRESET to select the band. Turn the jog dial to tune in the stored station. On the remote 1 Press BAND until the band you want appears in the display. 2 Press the number button to tune in a stored station. Tip When the AC power cord is disconnected and the batteries for the player are not inserted (but the back-up batteries are inserted), the time display on the display window becomes dim to prevent battery exhaustion. 24 2 Connecting the AC power cord Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Notes · Before you replace the batteries, be sure to take out the CD from the player. · When you operate the player on the batteries, you cannot turn on the player with remote. Tip When you operate the player on batteries, replace the back-up batteries when the time display dims or when you cannot operate the timer. Replace all the batteries with new ones. With normal use, the back-up batteries should last for about six months. To save the memory data, replace the batteries with the AC power cord connected. 3 Inserting batteries into the remote Insert two size AA (R6) batteries (not supplied) Setting Up Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. 4 Using the player on batteries Insert six size C (R14) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. Replacing batteries Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. 25 Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. [. . . ] · Move the player away from the TV. · If you are using the remote while listening to an AM radio, noise may be heard. The picture of your TV becomes unstable. · If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV. Remote The remote does not function. [. . . ]