User manual SONY CFD-E75L

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. The instructions in this manual are for the CFDE70L, CFD-E75, CFD-E75L and CFD-E77L. Before you start reading, check your model number. the CFD-E75L is the model used for illustration purpose. [. . . ] Make sure you have set the clock ("Setting the clock" on page 19). Set the timer to the hour you want the music to start by turning the jog dial, then press DSPL· Set the timer to the hour and the minutes you want the music to go off. Before you begin, make sure the (clock) indication is not lit in the display. Prepare the music source you want to play. To play the radio a CD Do this Tune in a station. The indication lights up and the power goes off. At the preset time, the power will go on, and the music will play. Then the power will go off at the preset time, and the player will enter into the standby mode. ALARM until "TIMER" appears in the display, then press DSPL· Select the music source ("Cd" or "RAdIO") by turning the jog dial, then press DSPL· ALARM until "TIMER" appears in the display, then DSPL· eNT MEM. Each time you press DSPL· To use the player before a timer playback starts Just turn on the player, and then you can use it. If you turn off the player before the preset time, timer playback will start at the preset time. In case of the radio, however, if you listen to the station which is different from the one you tuned in step 1 on page 20, you will hear that station at the preset time. Make sure to tune in the station you want to listen to before you turn off the player. To stop play Press OPERATE (or POWER) to turn off the power. notes · When you press STANDBY in step 7, make sure that n or z button of the tape player is not pressed. ⷠWhen you press n or z button of the tape player in the timer mode: If the tape length of one side is longer than the set time, the player will be turned off at the end of the tape, not at the set time. tips · To exit the standby mode, press STANDBY to make disappear from the display. ⷠThe preset settings remain until you reset them. Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90, and 120 minutes, allowing you to fall asleep while listening to music. Turn the jog dial to select the minutes until the player goes off automatically. Each time you turn the jog dial, the indication changes as follows: "60" t "90" t "120" t "OFF" t "10" t "20" t "30. Falling asleep to music (continued) To cancel the sleep function Press OPERATE (or POWER) to turn off the power. [. . . ] ⷠThe source which was recorded on TYPE II (high position) or TYPE IV (metal) tape using this unit is being played. Make sure the safety tab of the cassette is in place. Clean the heads, pinch roller and capstan (see page 30). Check to see if the AC power had been cut off. [. . . ]