User manual SONY CFD-E90L

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance. Notice for customers in the United Kingdom A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. [. . . ] Make sure to tune in the station you want to listen to before you turn off the player. To stop play Press OPERATE (or POWER) to turn off the power. notes · When you press STANDBY in step 7 on page 20, make sure that n or z button of the tape player is not pressed. ⷠWhen you press n or z button of the tape player in the timer mode: If the tape length of one side is longer than the set time, the player will be turned off at the end of the tape, not at the set time. tips · To exit the standby mode, press STANDBY to make disappear from the display. ⷠThe preset settings remain until you reset them. Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90, and 120 minutes, allowing you to fall asleep while listening to music. press CLOCK/SLEEP/TIMER until "SLEEP" appears in the display , and press ENTER. Turn the jog dial to select the minutes until the player goes off automatically. Each time you turn the jog dial, the indication changes as follows: "60" t "90" t "120" t "OFF" t "10" t "20" t "30. Falling asleep to music (continued) To cancel the sleep function Press OPERATE (or POWER) to turn off the power. Note When you are playing a tape using this function: If the tape length of one side is longer than the set time, the player will not go off until the tape reaches the end. tips · You can fall asleep and wake up to different music. Set the waking up timer first (see page 20), turn on the power, and then set the sleeping timer. However, you cannot store different radio stations. ⷠYou can set different volume for the waking up timer and the sleeping timer. For instance, you can sleep at lower volume and wake up at higher volume. You can use the AC power or batteries as a power source. Insert three R6 (size AA) batteries (not supplied) into the battery compartment. These batteries work to save the memory data. Note Before you replace the batteries, be sure to take out the CD from the player. To use the player on batteries, disconnect the mains lead from the player. [. . . ] ⷠMake sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light. ⷠMove closer to the player when using the remote. After trying the above remedies, if you still have problems, unplug the mains lead and remove all the batteries. After all the indications in the display disappear, plug the mains lead and insert the batteries again. [. . . ]