User manual SONY CFD-E90PS

[. . . ] 3-263-561-11 (1) CD Radio Cassette-Corder Operating Instructions CFD-E90 © 2004 Sony Corporation Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. Information For customers in the United States This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Press CLOCK/SLEEP/TIMER until "SLEEP" appears in the display, and press ENTER. Turn the jog dial to select the minutes until the player goes off automatically. Each time you turn the jog dial, the indication changes as follows: "60" t "90" t "120" t "OFF" t "10" t "20" t "30. " continued 21 Falling asleep to music (continued) To cancel the sleep function Press POWER to turn off the power. Note When you are playing a tape using this function: If the tape length of one side is longer than the set time, the player will not go off until the tape reaches the end. Tips · You can fall asleep and wake up to different music. Set the waking up timer first (see page 20), turn on the power, and then set the sleeping timer. However, you cannot store different radio stations. · You can set different volume for the waking up timer and the sleeping timer. For instance, you can sleep at lower volume and wake up at higher volume. 22 Setting Up Choosing the power sources You can use the AC power or batteries as a power source. Setting Up 14 Battery compartment AC IN 2 to a wall outlet 1 Inserting the back-up batteries Insert three size AA (R6) batteries (not supplied) into the battery compartment. These batteries work to save the memory data. Replacing batteries Take out the batteries as illustrated. Note Before you replace the batteries, be sure to take out the CD from the player. continued 23 Choosing the power sources (continued) 2 Connecting the AC power cord Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Notes · Before you replace the batteries, be sure to take out the CD from the player. · When you operate the player on the batteries, you cannot turn on the player with remote. Tip When you operate the player on batteries, replace the back-up batteries when the time display dims or when you cannot operate the timer. Replace all the batteries with new ones. With normal use, the back-up batteries should last for about six months. To save the memory data, replace the batteries with the AC power cord connected. 3 Inserting batteries into the remote Insert two size AAA (R03) batteries (not supplied). Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. 4 Using the player on batteries Insert six size C (R14) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. Replacing batteries Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. 24 Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. · Discs with non-standard shapes (e. g. , heart, square, star) cannot be played on this player. Attempting to do so may damage the player. On power sources · For AC operation, use the supplied AC power cord; do not use any other type. [. . . ] · Make sure the time on the clock is correct. · Check to see if the AC power had been cut off. · Make sure the (clock) indication is displayed. continued 27 Troubleshooting (continued) Remote The remote does not function. · Replace all the batteries in the remote with new ones if they are weak. [. . . ]