User manual SONY CFD-S20CP

[. . . ] 3-241-606-11 (1) CD Radio Cassette-Corder Operating Instructions CFD-S20CP ©2002 Sony Corporation Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. Information For customers in the United States This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Press the number buttons to tune in the stored station. To tune in a preset station over 10, press >10 first, then corresponding number buttons. (Example: To tune in a preset station 12, press >10 and 1 first, and then press 2. ) 20 The Audio Emphasis Adjusting the sound emphasis You can adjust the audio emphasis of the sound you are listening to. SOUND MEGA BASS The Audio Emphasis Selecting the sound characteristic Press SOUND repeatedly to select the audio emphasis you want. Choose To get powerful, clean sounds, emphasizing low and high range audio light, bright sounds emphasizing high and middle range audio percussive sounds, emphasizing bass audio the presence of vocals, stressing middle range audio the whole dynamic range for music such as classical music Reinforcing the bass sound Press MEGA BASS to display "MEGA BASS". To return to normal sound, press the button again. 21 The Timer Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90 and 120 minutes, allowing you to fall asleep while listening to music. SLEEP Note When you are playing a tape using this function: If the tape length of one side is longer than the set time, the player will not go off until the tape reaches the end. 1 2 3 Play the music source you want. Press SLEEP to display "SLEEP. " Press SLEEP to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" t "90" t "120" t "OFF" t "10" t "20" t "30". If 4 seconds have passed after you pressed SLEEP, the minutes in the display are entered. When the preset time has passed, the player goes off automatically. To cancel the sleep function Press POWER to turn off the power. 22 Setting Up Choosing the power sources You can use the AC power or batteries as a power source. 3 Battery compartment 1 AC IN Setting Up to a wall outlet 1 Connecting the AC power cord Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. 3 Using the player on batteries Insert six size D (R20) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. 2 Preparing the remote Insert two size AA (R6) batteries (not supplied). Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Replacing batteries Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. Notes · Before you replace the batteries, be sure to take out the CD from the player. · When you operate the player with the batteries, you cannot turn on the player with the remote. 23 Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. · Discs with non-standard shapes (e. g. , heart, square, star) cannot be played on this player. Attempting to do so may damage the player. On power sources · For AC operation, use the supplied AC power cord; do not use any other type. · The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use six size D (R20) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. [. . . ] At this time, you should demagnetize the heads and all metal parts in the tape path with a commercially available tape head demagnetizer. Cleaning the cabinet Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. Pinch roller Erase head Capstan Record/playback head After cleaning, insert a tape when the areas cleaned are completely dry. 28 Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 3. 2-ohm loads, both channels driven from 150 - 6, 300 Hz; rated 1. 8 W per channel-minimum RMS power, with no more than 10 % total harmonic distortion in AC operation. Battery life For CD radio cassette-corder: FM recording Sony R20P: approx. 386 × 166 × 252 mm (w/h/d) (15 1/4 × 6 5/8 × 10 inches) (incl. [. . . ]