User manual SONY CFD-S26L

[. . . ] A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, same rating fuse approved by ASTA or BSI to BS 1362, (i. As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. [. . . ] â· Make sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light. â· Move closer to the player when using the remote. After trying the above remedies, if you still have problems, unplug the mains lead and remove all the batteries. After all the indications in the display disappear, plug the power cord and insert the batteries again. Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. â· Do not place the player on an inclined or unstable place. â· Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. â· If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. â· Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. â· Do not stick paper or sticker on the CD, nor scratch the surface of the CD. â· After playing, store the CD in its case. If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error. This player is compatible with CD-Rs/CDRWs but playback capability may vary depending on the quality of the disc, the recording device and application software. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. Connect the mains lead A or insert six R20 (size D) batteries (not supplied) into the battery compartment B . Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. â· To use the player on batteries, disconnect the mains lead from the player. â· When you operate the player on batteries, you cannot turn on the player using the remote (CFD-S36/ S36L only). [. . . ] 3 Hold down the number buttons that you want to preset the new station on for about 2 seconds. To select the preset number over 10, press >10 first, then the corresponding number buttons. You need to hold down the last number button to enter for about 2 seconds. (Example: To select 12, press >10 and 1 first, then hold down 2 for about 2 seconds. [. . . ]