User manual SONY CFD-S28L

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. The instructions in this manual are for the CFD-S28L, CFD-S38, CFD-S38L and CFD-S55. Before you start reading, check your model number. the CFD-S38L is the model used for illustration purpose. [. . . ] If a station cannot be preset automatically You need to preset a station with a weak signal manually. 4 Press PRESET + or ­ until the preset number (1 to 10) you want for the station flashes in the music calender. Once you've preset the stations, use the number buttons on the remote or PRESET +/­ on the player to tune in to your favorite stations. Before you set the clock, connect the power source (see page 24). Press CLOCK for 2 seconds until the hour digit flashes. TUNE + or ­ until the correct minute is displayed. You can wake up to music or a radio program at a preset time. Make sure you have set the clock ("Setting the clock" on page 21). Before you begin, make sure the t (clock) indication is not lit in the display. Prepare the music source you want to play. To play the radio a CD Do this Tune in a station Insert a CD Set the timer to the hour you want the music to start by pressing TIME SET· Set the timer to the hour and the minutes you want the music to go off. To exit the standby mode, press STANDBY to make tdisappear from the display. ⷠThe preset settings remain until you reset them. The t indication lights up and the power goes off. At the preset time, the power will go on, and the music will play. Then the power will go off at the preset time, and the player will enter into the standby mode. To check/change when the playback will start Press TIMER, then DISPLAY ENT· mEMORY. Each time you press DISPLAY ENT· To use the player before a timer playback starts Just turn on the player, and then you can use it. If you turn off the player before the preset time, timer playback will start at the preset time. In case of the radio, however, if you listen to the station which is different from the one you tuned in in step 1 on page 22, you will hear that station at the preset time. Make sure to tune in the station you want to listen to before you turn off the player. To stop play Press OPERATE (or POWER) to turn off the power. [. . . ] ⷠThe source which was recorded on TYPE II (high position) or TYPE IV (metal) tape using this unit is being played. Make sure the safety tab of the cassette is in place. Clean the heads, pinch roller and capstan (see page 32). Check to see if the AC power had been cut off. [. . . ]