User manual SONY CFD-S47

[. . . ] 3-864-534-51(1) CD Radio Cassette-Corder Operating Instructions CFD-S47 ©1998 by Sony Corporation Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. Information For customers in the United States This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The t indication lights up and the power goes off. The Timer At the preset time, the power will go on, and the music will play. Then the power will go off at the preset time, and the player will enter into the standby mode. To check/change when the playback will start Press TIMER, then DISPLAY·ENTER MEM. Each time you press DISPLAY·ENTER MEM, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and reenter it. To use the player before a timer playback starts Just turn on the player, and then you can use it. If you turn off the player before the preset time, timer playback will start at the preset time. In case of the radio, however, if you listen to the station which is different from the one you tuned in in step 1 on page 22, you will hear that station at the preset time. Make sure to tune in the station you want to listen to before you turn off the player. To stop play Press POWER to turn off the power. The Timer 23 Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90, and 120 minutes, allowing you to fall asleep while listening to music. SLEEP Tips · The display window does not light while the sleeping timer is on. · You can fall asleep and wake up to different music. Set the waking up timer first (see page 22), turn on the power, and then set the sleeping timer. However, you cannot store different radio stations. Note When you are playing a tape using this function: If the tape length of one side is longer than the set time, the player will not go off until the tape reaches the end. 1 2 3 Play the music source you want. Press SLEEP to display "SLEEP. " Press SLEEP to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" n "90" n "120" n no indication n "10" n "20" n "30. " To cancel the sleep function Press POWER to turn off the power. 24 The Timer Setting Up Choosing the power sources You can use the AC power or batteries as a power source. AC IN 14 Battery compartment Setting Up 2 to a wall outlet 1 Inserting the back-up batteries Insert four size AA (R6) batteries (not supplied) into the battery compartment. These batteries work to save the memory data. Replacing batteries Take out the batteries as illustrated. 2 Connecting the AC power cord Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. continued Setting Up 25 Choosing the power sources (continued) 3 Inserting batteries into the remote Insert two size AA (R6) batteries (not supplied) Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Note When you operate the player on batteries, ­ the backlight in the display does not light. ­ you cannot turn on the player using the remote. Tip Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. 4 Using the player on batteries Insert six size D (R20) batteries (not supplied) into the battery compartment. [. . . ] · Clean the erasing head (see page 32) · Replace all the batteries with new ones if they are weak. · The source which was recorded on TYPE II (high position) or TYPE IV (metal) tape using this unit is being played. Record on TYPE I (normal) tape and play. Tape Player The tape does not record. · Make sure the tape is inserted properly. · Make sure the safety tab of the cassette is in place. [. . . ]