User manual SONY CFD-V14

[. . . ] To record from a USB device, press USB on the unit and connect the USB device. To record from the radio, tune in the station you want (see "Listening to the radio"). . 2 Select the program source you want to record. ­ to go 5 Press ENTER on the unit. Recording starts. The red indicator stops blinking and turns on during the recording. The unit and the USB device automatically stop when the recording is completed. + to go forward and backward . Operating Instructions GB (forward) or (backward) while playing and hold it until you find the point ( or 3 Press on the unit to start recording ( is depressed automatically). To Pause recording Press on the unit. [. . . ] Track number Playing time MP3/WMA disc (Example: When you place MP3 disc) Radio section 2 Press on the unit. The unit starts playing. To Pause playback Press on the unit. To resume play, press it again. on the unit. or (rewind or fast forward) on the unit. on the unit. Frequency range FM: 87. 5 - 108 MHz AM: 531 - 1 611 kHz (9 kHz step) 530 - 1 610 kHz (10 kHz step) Antennas FM: Telescopic antenna AM: Built-in ferrite bar antenna FM recording Sony R20P: approx. 18 h Cassette-corder section Recording system 4-track 2 channel stereo Fast winding time Approx. 150 s (sec. ) with Sony cassette C-60 Frequency response TYPE I (normal): 70 - 13 000 Hz Tape playback Sony R20P: approx. 6 h MP3/WMA file number After the song title is displayed, the playing time* will appear. Stop playback Fast-forward or rewind Eject the cassette Synchro Recording This function allows you to easily record an entire disc onto a USB device. CD playback Sony R20P: approx. 551 × 263 × 380 mm (w/h/d) (incl. batteries) Supplied accessories AC power cord (1) Remote control (1) Design and specifications are subject to change without notice. * If the playing time is more than 100 minutes, it appears as "--:--" in the display. 1 Connect a USB device with recording capability to USB section Supported bit rate MP3 (MPEG 1 Audio Layer-3): 32 - 320 kbps, VBR WMA: 16 - 320 kbps, VBR Sampling frequencies MP3 (MPEG 1 Audio Layer-3): 32/44. 1/48 kHz WMA: 32/44. 1/48kHz (USB) port USB-A (Full Speed) the (USB) port . If a USB cable is necessary, use the USB cable supplied with the device to be connected. Refer to the operation manual supplied with the USB device for connection details. It is a recording standard used for Audio CDs. "REC ERROR" appears. An error occurred during the recording. Turn off the Checking the information of an audio CD To check the total track number and playing time of the CD Press while the CD is stopped, and you can check them in the display. 1 Press CD . "CD" appears in the display. Discs that this unit CANNOT play CD-R/CD-RW other than those recorded in music CD 2 Press MODE until "PGM" appears in the display. 3 Press or then press DSPL/ENT on Total track number Total playing time Checking the information of an MP3/WMA disc To check the total folder number and total file number on the CD Press while the CD is stopped, and you can check them in the display. MP3/WMA disc (Example: When you place MP3 disc) the unit (ENTER on the remote) for the tracks/ MP3/WMA files you want to program in the order you want. For MP3/WMA files, press TUNE + or ­ first and then press or and DSPL/ENT (ENTER on the remote). After programming the first track, "STEP 1" appears, followed by the selected track/MP3/WMA file. Each time you add a track/MP3/WMA file, a step number is added. The total time of the program play will be displayed up to "99:59" for the CD (If the total time count becomes more than 99:59, "--:--" will be displayed. For MP3/WMA, "--:--" will be always displayed. ) Audio CD (Program Play) goes off automatically. Each time you press the button, the indication changes as follows: "AUTO*" "60MIN" "30MIN" "20MIN" "10MIN" "OFF". * When you select "AUTO", the CD, USB or tape stops playing in 90 minutes at most and the unit goes off automatically. When you are listening to the radio, the radio goes off in 90 minutes. format or MP3/WMA format conforming to ISO9660 Level 1/Level 2 or Joliet CD-R/CD-RW of poor recording quality, CD-R/CD-RW that has scratches or are dirty, or CD-R/CD-RW recorded with an incompatible recording device CD-R/CD-RW which is finalized incorrectly operate the unit on batteries. There is no audio. Make sure the function you want to use appears in the Unplug the headphones when listening through unit and remove the connected USB device. Make sure of the following: ­ The USB device is not full. [. . . ] If the problem persists, please consult your nearest Sony dealer. "OVER CURRENT" appears. 1 Press CD . "CD" appears in the display. Playing preset radio stations 1 Press RADIO/BANDAUTO PRESET on the unit to select the band. stored station. 1 Connect the built-in audio cable with stereo-mini 2 Turn the unit and the connected component on. 3 Press AUDIO IN on the unit and start playing plug on the unit to the line output jack of the portable digital music player or other components*. An abnormal level has been detected in the electrical 2 Press MODE until "SHUF" appears in the display. When you select Folder Shuffle Play (MP3/WMA disc only), press MODE on the unit until " " and "SHUF" appear in the display. Then press TUNE + or ­ on the unit to select a folder you want. 2 Press PRESET + or ­ on the unit to tune in the On the remote 3 Press on the unit to start Shuffle Play. On the remote Use instead of . sound on the connected component. [. . . ]