User manual SONY CFD-V17

[. . . ] Record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. WARNING Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. The FUNCTION selector is located at the front. When you turn on the player, the OPR/BATT indicator lights up. [. . . ] After you've created the program, insert a blank tape and press r to start recording. 1 2 3 Set FUNCTION to CD. Press PLAY MODE until "PGM" appears in the display. Press the = or + then press DISPLAY· ENTER for the tracks you want to program in the order you want. Playing order Programed track 4 Press ^ to start program play. To cancel Program Play Press PLAY MODE until "PGM" disappears from the display. To change the current program Press p once if the CD is stopped and twice if the CD is playing. Then create a new program following the programing procedure. 16 The CD Player Setting Up Choosing the power sources You can use the AC power or batteries as a power source. Use the AC power source whenever you record since recording consumes much power. Battery compartment AC IN Setting Up To a wall outlet Connecting the AC power cord Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Tip Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. Using the player on batteries Insert six size D (R20) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. Setting Up 17 Adjusting the sound emphasis (TONE/MEGA BASS) You can adjust the tone. You can also reinforce the bass sound. MEGA BASS TONE Adjusting the tone Turn TONE. Turn the control toward HIGH to enhance the high tone and toward LOW to enhance the low tone. Reinforcing the bass sound Press MEGA BASS to ON. To return to normal sound, press the button to 18 Setting Up Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. On power sources · For AC operation, use the supplied AC power cord; do not use any other type. · The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use six size D (R20) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. · Do not place anything within 10 mm of the side of the cabinet. [. . . ] Cleaning the tape heads and tape path Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours of operation for optimum playback and recording quality. To make the best possible recording, however, we recommend that you clean all surfaces over which tape travels before each recording. Record/playback head Capstan Demagnetizing the tape heads After 20 to 30 hours of use, enough residual magnetism will have built up on the tape heads to begin to cause loss of high frequency sound and hiss. At this time, you should demagnetize the heads and all metal parts in the tape path with a commercially available tape head demagnetizer. Cleaning the cabinet Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. [. . . ]