User manual SONY CFD-V24

[. . . ] Refer to these numbers whenever you call upon your Sony dealer regarding this product. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. the FUNCTION selector is located on the top exterior. When you turn on the player, the OPR/BATT indicator lights up. [. . . ] You can arrange the playing order of the tracks on a CD. You can play the same program again, since the program is saved until you open the CD compartment or switch FUNCTION. After you've created the program, insert a blank tape into deck B and press r on deck B to start recording. Press + or = AMS/SEARCH then press DISPLAY/ENT for the tracks you want to program in the order you want. Programed track Playing order Press p once if the CD is stopped and twice if the CD is playing. Then create a new program following the programing procedure. You can use the AC power or batteries as a power source. Use the AC power source whenever you record since recording consumes much power. Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Tip Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. replace all the batteries with new ones. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. Before playing, clean the CD with a cleaning cloth. Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. â· Do not stick paper or sticker on the CD, nor scratch the surface of the CD. â· After playing, store the CD in its case. If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error. To record on a tape with its tab broken off, cover the respective tab hole for side A or B with adhesive tape. â· The use of a cassette with more than 90 minutes of play time is not recommended except for long, continuous recording or playback. Make sure the batteries are inserted correctly. [. . . ] clean with a commercially available blower. Cleaning the tape heads and tape path Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours of operation for optimum playback and recording quality. To make the best possible recording, however, we recommend that you clean all surfaces over which tape travels before each recording. Demagnetizing the tape heads After 20 to 30 hours of use, enough residual magnetism will have built up on the tape heads to begin to cause loss of high frequency sound and hiss. [. . . ]