User manual SONY CFD-V3

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] You can arrange the playing order of the tracks on a CD. 3 Press the number buttons on the remote for the tracks you want to program in the order you want. You can play the same program again, since the program is saved until you open the CD compartment or switch FUNCTION. After you've created the program, insert a blank tape and press r to start recording. Press the = or + then press DISPLAY/ ENTER for the tracks you want to program in the order you want. Playing order Programed track Press PLAY MODE until "PGM" disappears from the display. To check the order of tracks before play Press DISPLAY/ENTER. Every time you press the button, the track number appears in the programed order. Press p once if the CD is stopped and twice if the CD is playing. Then create a new program following the programing procedure. You can use the AC power or batteries as a power source. ⷠIf the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. ⷠSince a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. on operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. ⷠIf the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. Before playing, clean the CD with a cleaning cloth. Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. [. . . ] ) · Replace all the batteries with new ones if they are weak. The picture of your TV becomes unstable. The CD does not play/"no disc" lights in the display even when a CD is in place. The tape does not move when you press an operation button. [. . . ]