User manual SONY CFD-V37L

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. Notice for customers in the United Kingdom A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, same rating fuse approved by ASTA or BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Use the AC power source whenever you record since recording consumes much power. To a wall outlet Tip Only for the customers supplied with an AC plug adaptor: Use the supplied AC plug adaptor if the plug of the AC power cord does not match your outlet. Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Adjusting the voltage (CFD-V25/V34/V37 only) Be sure to set the VOLTAGE SELECTOR (at the bottom) to your local power supply. Note When you operate the player with the batteries, you cannot turn on the player using the remote. Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Tip Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. Using the player on batteries insert six R20 (size D) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. You can adjust the audio emphasis of the sound you are listening to. To return to normal sound, press the button again. As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. on power sources · For AC operation, check that the player's operating voltage is identical with your local power supply (see "Specifications") and use the supplied AC power cord; do not use any other type. The voltage selector is located at the bottom of the player (CFD-V25/ V34/V37 only). ⷠThe player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. ⷠDo not place the player on an inclined or unstable place. [. . . ] ⷠMove the player away from the TV. ⷠIf you are using the remote while listening to AM or MW/LW radio, noise may be heard. If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV. The CD does not play/"no disc" lights in the display even when a CD is in place. [. . . ]