User manual SONY CFD-ZW200

[. . . ] 3-859-373-12(1) CD Radio Cassette-Corder Operating Instructions CFD-ZW150 CFD-ZW160 CFD-ZW200 ©1996 by Sony Corporation CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. Information For customers in the United States This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] "SLEEP" appears in the display. The player shuts off automatically after about 2 hours. To cancel the sleep function Press SLEEP again. The Timer 19 CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Setting Up Hooking up the 2 Speaker terminals system Make sure you turn off the power before making any connections. Speaker cords Right speaker 1 5 Battery compartment Left speaker 3 To a wall outlet 1 Inserting the back-up batteries Insert three size AA (R6) batteries (not supplied) into the battery compartment. These batteries work to save the memory data. Tips · To detach the speakers, unlock speaker (see B on the diagram) and slide the speaker box all the way up and away from the player. · Connect the speakers for this unit only to the speaker terminals of this unit. If you connect any other speakers or equipment, malfunction may occur. 2 Hooking up the speakers 1 Align the grooves and slide the speaker box down until it snaps into place A. 20 Setting Up CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 2 Twist the speaker cable coating and strip it from the end of the cable. 3 Connect the black wires to (­) minus and the red wires to (+) plus terminals; the right speaker wires to the R and the left speaker wires to the L terminals. Setting Up 3 Connecting the AC power cord Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Note When you operate the player with the batteries, you cannot turn on the player using the remote (CFDZW160/ZW200 only). 4 Inserting batteries into the remote (CFDZW160/ZW200 only) Insert two size AA (R6) batteries (not supplied) Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. continued Setting Up 21 CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Hooking up the system (continued) Note When you operate the player with batteries, the backlight does not work even if the player is on. Tip Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. 5 Using the player on batteries Insert eight size D (R20) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. 22 Setting Up CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Adjusting the audio emphasis (MEGA BASS/4 BAND GRAPHIC EQUALIZER/SURROUND) You can adjust the audio emphasis of the sound you are listening to. SURROUND MEGA BASS 4 BANDGRAPHIC EQUALIZER Setting Up Selecting the sound characteristic Slide 4 BAND GRAPHIC EQUALIZER to select the audio emphasis you want. Frequency coverage 400 Hz Slide the control up (to +10) to emphasize speaking voice, middle frequencies of instrumental music to provide more presence of vocals to heighten overall brightness of sound to increase high treble sounds Slide the control down (to ­10) to de-emphasize speaking voice, middle frequencies of instrumental music to provide less presence of vocals to lessen overall brightness of sound to decrease high treble sounds or reduce high frequency noise/tape hiss 1 kHz 4 kHz 10 kHz Reinforcing the bass sound Press MEGA BASS. "MEGA BASS" appears in the display. You can reinforce the bass sound in two steps. To return to normal sound, press the button until "MEGA BASS" disappears form the display. continued Setting Up 23 CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Adjusting the audio emphasis (MEGA BASS/4 BAND GRAPHIC EQUALIZER/SURROUND) (continued) Getting the surround effect (CFD-ZW160/ ZW200 only) Press SURROUND. The "SURROUND" indication appears in the display. You can get the surround effect without connecting surround speakers. 24 Setting Up CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. On power sources · For AC operation use the supplied AC power cord; do not use any other type. · The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use eight size D (R20) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. [. . . ] · Clean the heads, pinch rollers and capstans (See page 29). · Demagnetize the heads using a demagnetizer (see page 29). · The TYPE II (high position) or TYPE IV (metal) tape is being used. · Make sure the time on the clock is correct. [. . . ]