User manual SONY CFD-17

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] Set the minutes by pressing TIME SET +/­ until the current minute is displayed. 3 Press DISPLAY/ENTER. The clock starts from 00 seconds. 16 The Timer CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Waking up to music You can wake up to music at a preset time. Make sure you have set the clock ("Setting the clock" on page 16). STANDBY TIMER DISPLAY/ ENTER TIME SET+/­ The Timer 1 Prepare the music source you want to play. To play the radio a CD Do this Tune in a station Insert a CD. 2 3 4 5 Press TIMER for about 2 seconds. The t (clock) and the music source ("Cd" or "RAdIO") flash. Select the music source ("Cd" or "RAdIO") by pressing TIME SET +/­, then DISPLAY/ENTER. Set the timer to the hour you want the music to start by pressing TIME SET +/­ then DISPLAY/ ENTER. Set the minutes, then press DISPLAY/ ENTER. Press TIME SET +/­ to set the volume, then DISPLAY/ENTER. continued The Timer 17 CFD-ZW150/. ZW160/ZW200. E_3-859-373-1X. U2/CA2/AU6 Waking up to music (continued) Tips · The display window dims while the waking up timer is on. · You can have the player go on the next day at the same time. Just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use eight size D (R20) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. [. . . ] · Make sure "TAPE" appears in the display. · Clean the erasing head (see page 29. ) · Replace all the batteries with new ones if they are weak. · Make sure the tape is inserted properly. · Make sure the safety tab of the cassette is in place. [. . . ]